Schneider Easy9 in Acti9 board

Eric12 · Nov 14, 2022

Hi, anyone know if a Schneider Easy9 Mainswitch & RCBO's will fit in a Acti9 board ? The Acti9 board in question is fitted in a single ph domestic dwelling and I want to swap out the existing mainswitch RCCB with a 100a switch which is Easy9 fare. Similarly will Easy9 RCBO's fit an Acti9 board ? Anyone know ? Ive emailed and called Schneider tech support with no response. Thanks

sylvn86 · Jun 6, 2023

Eric12 said:
Hi, anyone know if a Schneider Easy9 Mainswitch & RCBO's will fit in a Acti9 board ? The Acti9 board in question is fitted in a single ph domestic dwelling and I want to swap out the existing mainswitch RCCB with a 100a switch which is Easy9 fare. Similarly will Easy9 RCBO's fit an Acti9 board ? Anyone know ? Ive emailed and called Schneider tech support with no response. Thanks

HI Eric did you find out? I'd like to know the same

happysteve · Jun 7, 2023

I found Schneider to be unusually helpful with technical queries; I asked them if they had a Type A RCCB that was compatible with an old Domae DB. They replied within a day offering 2 models (63A or 100A), with part numbers, and an attached PDF "Statement of Backwards Compatibility". I was pretty impressed!

I contacted them through a form on their website, after that it was all via email.

Pretty sure this is where the form is: Contact UK Customer Support - https://www.se.com/uk/en/work/support/customer-care/contact-schneider-electric.jsp

Eric12 · Jun 7, 2023

sylvn86 said:
HI Eric did you find out? I'd like to know the same

If my memory serves me correct I dont they do. I think I ended up leaving the rcd main switch in as customer refused a new cu

sylvn86 · Jun 12, 2023

happysteve said:
I found Schneider to be unusually helpful with technical queries; I asked them if they had a Type A RCCB that was compatible with an old Domae DB. They replied within a day offering 2 models (63A or 100A), with part numbers, and an attached PDF "Statement of Backwards Compatibility". I was pretty impressed!

I contacted them through a form on their website, after that it was all via email.

Pretty sure this is where the form is: Contact UK Customer Support - https://www.se.com/uk/en/work/support/customer-care/contact-schneider-electric.jsp

Thanks for the tip, I got in touch one evening and they replied a few hours later at 2am apologising for the delay!

They confirmed that as suspected, the Easy9 devices do not fit in the Acti9 boards