dusk

Recent contents Top users
  1. GBDamo

    Dusk 'til Dawn Only Flood Light.

    Customer wants a Dusk 'til Dawn only 50W+ flood light. Currently he has the normal stand alone photo cell with a standard LED flood but is complaining that "its either one or the other" that goes and he would rather the photo cell be replaced with a JB and have a flood mounted sensor, but no...
  2. Z

    Dual Output floodlight replacement

    Hi all, need to replace a failed 500w halogen PIR floodlight. This one was a dual output model that had an adjustable dimmer on the PIR housing for setting night time dusk to dawn illumination but switched to full brightness when it detected motion. Has anybody come across an LED floodlight with...
  3. B

    replace motion sensor with dawn to dusk

    I'm replacing a motion sensor for an outside light with a dawn to dusk one. Going into existing sensor 6 cables see pic. the dawn to dusk sensor has these inputs: Can somebody tell me please what cables go into which input on the new sensor? Many thanks.
  4. J

    All-Pro Dusk to Dawn 110 deg. Fluorescent Bronze Walk Light Fixture Hardwired

    I had the All Pro dusk to dawn installed in 2015..the light bulb burned out last week. The electrician replaced the fluorescent bulb. That night it did not light although they checked the bulb earlier it worked. I read where you might have to reset breaker so I did and the light worked two...
  5. R

    Dusk to dawn lamp

    Fitted a new outside light for customer and dusk to dawn lamp, the lamp keeps flashing off and on every 20 seconds. Found the fault to be the reflection from the clear plastic housing is lighting up the photocell and causing the lamp to switch off, then in darkness the lamp switches on again...
    • Rappid
    • Thread
    • direct dusk index lamp lamps photocell sensor
    • Replies: 9
    • Forum: Lighting Forum
  6. M

    Dusk to Dawn Sensor with PIR facility ?!

    Good evening, Ive had a request from a customer to have to wall mounted garage lights illuminate for approx 4/6 hours controlled via a dusk to dawn sensor however when this time period expires they then wish the lights to operate via a PIR similar to a standard security light such that when an...
  7. B

    Advice needed on how to power 2 single LED's from Dusk to Dawn using Solar.

    I have posted here a the 'DIY Electrical Advice' is locked preventing me from posoting. I would like to power 2 superbrite LED’s, any voltage, 12v, 5v or whatever. I want the LED’s to come on a dusk and off at dawn and I would prefer them to be powered by a battery, I’m thinking something like...
  8. E

    customer wants lights on at dusk till 1am and then switch to pir sensor till dawn

    Hi new on here looking for a bit of advice. I can find pir sensors that will allow lights to come on and stay on for a specific amount of time (1-8 hours) and then switch to motion sensor till dawn but not to switch over at a specific time. Any help gratefully received
    • East1
    • Thread
    • customer dusk lighting lights pir sensor switch wants
    • Replies: 26
    • Forum: UK Electrical Forum
  9. stef

    Dusk to dawn switch

    Hi chaps, Well, I have one of them Fitted it 10 years ago, still working! Till recently. Going green I decided to replace the outside lights with LED types and splashed out 40 quid. Now, after dusk, the lights come on for 5 seconds and then go off for a couple of minutes and so on. Pretty...
  10. N

    Outside lights dusk till Dawn pulsing

    Hi Job from hell!!! Been called to some dusk till dawns that are faulty When first went 2 were pulsing on and off and one was fine. Found a dodgy bit of cable between 2 of them so changes that and check are set correctly for dusk till Dawn and also installed 2 new 26w 4pin lamps into them...
  11. A

    HI LO Dawn to Dusk Lights

    Hi Guys, Bought a White Half Lantern HI LO Dawn To Dusk light with Motion Detector from Homebase and installed it on Sunday, but the light does not come on when it gets dark like it should? It does sometimes come on when there is motion but not always? I got some of the 1mm cable and wired...
    • Andy Woodlock
    • Thread
    • aus dusk lighting lights
    • Replies: 7
    • Forum: Australia
  12. M

    dusk till dawn sensor

    just been to an install today as they have a dusk till dawn sensor controlling the outside lights 28 twin earths connected to sensor they want the sensor removing and adding a switch to control the lights just wondering when i remove this should i just put an adaptable box and join the cable...
  13. A

    what dusk mask do you use?

    hi all just wondering what dust mask you use when working on old houses etc when chasing walls and disturbing ceilings? what with asbestos now being mentioned on the radio everyday and i've known some people to die from the evil stuff. i use the drager fp3 but thinking of buying the full face...
    • ab1978
    • Thread
    • aus dusk
    • Replies: 8
    • Forum: Australia

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

Tags

advice aus cable circuit course earth electric electrical electrician hello led light lighting lights looking new please question rcd socket supply switch testing training wiring
This website was designed, optimised and is hosted by Untold Media. Operating under the name Untold Media since 2001.
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock