!7th & PVC conduit

[lionelmcc]

H Chaps,

Can anyone tell me if the new regs require RCD protection for PVC conduit run to metal clad 20a DP switch? and also to a lighting circiut where the wiring is in minitrunking?

old dog learning new tricks (of the trade)

L

 

[Spudnik]

Basically no, as they are surface mounted.

 

[Guest123]

Agreed.

Only query I might have is what is the 20A switch controlling?

 

[dazza69]

Does this mean we're gonna see the return of the council style re-wire where all is surface mounted so only RCD for Ground floor sockets!!! Tee Hee!!

 

[lionelmcc]

I didn't think so.

It's a small workshop with a 3 horse power table saw saw
The plan is to run 2.5 singles in conduit to the 20a switch for the saw; a 16a C type breaker should accommodate the start up induction current (around 15a and then run @ around 9a).
Lighting in conduit to wall plate level then in minitrunking to HF fluorescents, with non maintained emergency bulkhead on the phase.
RFC on 32a RCBO

Have I covered it?

 

[WB Scott]

Does this mean we're gonna see the return of the council style re-wire where all is surface mounted so only RCD for Ground floor sockets!!! Tee Hee!!

What about RCD protection on sockets for non-instructed/ skilled persons? eg the home owner.

 

[lionelmcc]

What about RCD protection on sockets for non-instructed/ skilled persons? eg the home owner.

RFC on 32a RCBO

 

[Mark2009]

Hi
Could someone tell me what D10 Domestic electrical installation certificate is, there seems to be lots of certificates out there.

Thanks

Mark

 

[Spudnik]

Hi Mark,

Hate to state the obvious but its exactly that.

These are green certs sold by NIC for contractors not registered with them.

Domestic Electrical Installation Certificates - QVS Electrical Supplies | Electrical Wholesale

 

[Mark2009]

Hi Mark,

Hate to state the obvious but its exactly that.

These are green certs sold by NIC for contractors not registered with them.

Domestic Electrical Installation Certificates - QVS Electrical Supplies | Electrical Wholesale

Hi i know this but can you sign off work say my mothers house?

Sorry i posted in the wrong section.

Thanks

Neil

 

[Spudnik]

Hi i know this but can you sign off work say my mothers house?

Sorry i posted in the wrong section.

Thanks

Neil

Start a new thread mate

 

[lionelmcc]

well we seem to have lost the thread

 

[Spudnik]

No its still here Lionel

 

[lionelmcc]

any other suggestions?

 

[Spudnik]

Well i think you have just about got it covered.

No RCD protection for lighting and 20A radial and RCBO on socket outlets.

Job done!

 

[Guest123]

I didn't think so.

It's a small workshop with a 3 horse power table saw saw
The plan is to run 2.5 singles in conduit to the 20a switch for the saw; a 16a C type breaker should accommodate the start up induction current (around 15a and then run @ around 9a).
Lighting in conduit to wall plate level then in minitrunking to HF fluorescents, with non maintained emergency bulkhead on the phase.
RFC on 32a RCBO

Have I covered it?

That all looks fine Lionel.

 

[lionelmcc]

thanks guys