Can anybody identify what bulb i need for this fitting?

[Leehynes]

Sorry if this isn't what this forums for but I'm at a loss and any help would be greatly appreciated, can anybody identify what bulb i need for this fitting?

It's an outdoor light if that's any help,

 

[DT1991]

13w 2 pin PL-C

 

[Leehynes]

13w 2 pin PL-C

Brilliant that's what I was looking at on amazon but wasnt sure because of the 4 grooves , thankyou very much

 

[westward10]

It is a G24d-1 13w tube.

 

[Phil Thompson]

I've 2 in the van lol

 

[telectrix]

alternative to amazon,

13W Push Fit CFL G24D-1 2pin PL-C 780 Lumens 2700K/4200k

13W Push Fit CFL G24D-1 2pin PL-C - Rated Life of 8000 hours. 13 watts rated equivalent to a 75 watt traditional filament incandescent bulb. Dimensions : Length 138mm with bottom cap widths of 32 and 32mm This PL lamp is available in a warm white 2700k or natural white 4000k colour temperature...

www.saving-light-bulbs.co.uk

 

[Midwest]

Just remember the 'bulb' pushes in & out, doesn't twist etc (not on about dancing).

 

[Leehynes]

? I've encountered a problem.
The bulb fits and attempts to light up but doesn't quite fully and flickers, is it worth trying to rescue the outdoor fixture which I've put the bulb in to, or is there a part I could get for it?
I've seen a bulb in my quest that was 'ballast bypass' with the same fitting... would this help?

 

[gazdkw82]

Sounds like the gear (ballast) faulty.

Either replace that or retrofit an LED equivalent.

Or just change the fitting