Test Meter - Forum Sponsors since 2007!
This official sponsor may provide discounts for members
Advertisement - Content continues below
Advertisement - Content continues below

Discuss can some one anser this please in the Commercial Electrical Advice area at ElectriciansForums.net

M

mike

Welcome to ElectriciansForums.net - The American Electrical Advice Forum
Head straight to the main forums to chat by click here:  American Electrical Advice Forum

hi can some one please anser this for me. i have used a over haed catinary to support a 1mm t&e i have ran a sperate 6mm earth and connected it to the catenary, it is metal so it must be earthed, what size earth should i have used to earth the catenary wire. thanks
 
Aico 3000 Range
This official sponsor may provide discounts for members
Advertisement - Content continues below
C

Cirrus

  • Thread Starter Thread Starter
  • #2
hmm, not sure but although 6mm should be adequate, I would have probably stuck in 10mm earth same as an earth rod or main bonding just to b safe
 
W

wayne

  • Thread Starter Thread Starter
  • #4
if the catenary wire needed earthing then what would it be classed as ,personally i'd just put in same size as gas or water (main equipotential bonding)
 
Aico 3000 Range
This official sponsor may provide discounts for members
Advertisement - Content continues below

Reply to can some one anser this please in the Commercial Electrical Advice area at ElectriciansForums.net

Wetroom Store - Network Wetroom Suppliers
This official sponsor may provide discounts for members
Advertisement - Content continues below
Top Bottom