Hi guys,
Been getting a bit of practice with my new Metrel MI3000.
Most functions are fine, but I'm a little confused by the Z Loop impedance test.
In the book, it shows the Line, Neutral and PE probes being connected to their respective terminals on the board.
When I do this and press test, the machine reboots and gets confused.
However, when I connected the Neutral and PE probes together on the earthing terminal all was fine and I got a realistic reading.
Anyone know what I'm doing wrong/right?!
Been getting a bit of practice with my new Metrel MI3000.
Most functions are fine, but I'm a little confused by the Z Loop impedance test.
In the book, it shows the Line, Neutral and PE probes being connected to their respective terminals on the board.
When I do this and press test, the machine reboots and gets confused.
However, when I connected the Neutral and PE probes together on the earthing terminal all was fine and I got a realistic reading.
Anyone know what I'm doing wrong/right?!