SuperlecDirect - ElectriciansForums.net Electrical Suppliers
This official sponsor may provide discounts for members

Discuss creatures of habit! (inspection and test) in the Electrical Courses and Electrical NVQ's area at ElectriciansForums.net

B

bigstew

Welcome to ElectriciansForums.net - The American Electrical Advice Forum
Head straight to the main forums to chat by click here:  American Electrical Advice Forum

hi
i will be doing the inspection and test part of my cg2330 302 + 303 when i go back to night school in september and i just wondered if i could get some tips and tricks to help me remember certain procedures of the process. i know CRIP i just wondered if anyone has any things they do before starting (or finishing) the test or anything i should look for brfore i start (or finishing) my tests.

any help or advise would be greatly appreiciated:D

cheers stew
 
Last edited by a moderator:
uHeat Banner - Forum Discount Available
This official sponsor may provide discounts for members
E

EasyFox

  • Thread Starter Thread Starter
  • #2
Isolate the whole cu & circuit ocpd's then using a length of cable with croc clips either end connect the busbar to the earth terminal.
Turn on each mcb in turn & test R1+R2 of the circuit.
Saves having to dick about removing line conductors from ocpd's, REMOVE THE LINK BEFORE RE-ENERGISING

 
CK Tools :) The professionals choice when it comes to Electrical Tools
This official sponsor may provide discounts for members

Reply to creatures of habit! (inspection and test) in the Electrical Courses and Electrical NVQ's area at ElectriciansForums.net

SuperlecDirect - ElectriciansForums.net Electrical Suppliers
This official sponsor may provide discounts for members
Top Bottom