hi i`ve been using a bg energy monitor for aweek or so,however it reads the output of my solar panels sometimes eg panels producing 2.5kw meter says 2.8kw (300w house load) at other times it doesnt.i dont understand how the ct coil is getting confused any ideas.
also i`ve found a supplier of low watt immersion heaters is there anything on the market that monitors load vs energy produced and can sw a load on when production is say 1kw (500w house load + 500w heater) and will sw load relay off if production drops below 1kw
thanks dave
also i`ve found a supplier of low watt immersion heaters is there anything on the market that monitors load vs energy produced and can sw a load on when production is say 1kw (500w house load + 500w heater) and will sw load relay off if production drops below 1kw
thanks dave