Advertisement - Content continues below
Advertisement - Content continues below

Discuss fixed items in bath rm in the Electrical Forum area at ElectriciansForums.net

B

beaver74

Welcome to ElectriciansForums.net - The American Electrical Advice Forum
Head straight to the main forums to chat by click here:  American Electrical Advice Forum

if a fixed item is fixed out of zone 2 as i read it there is no need to have any special ip rating as there is no reg concerning out of zone2 obviously any leed should be short enougth that it is not of any danger

rcd of course
 
Aico Carbon Monoxide Detectors
This official sponsor may provide discounts for members
Advertisement - Content continues below
P

pushrod

  • Thread Starter Thread Starter
  • #2
I think sockets have to be 3 or more metres from the boundary between zone 1 and 0 , not sure about fixed items though.
 
Last edited by a moderator:
S

Spudnik

  • Thread Starter Thread Starter
  • #3
Regardless of zones, to a point, any accessory should be chosen and installed according to the environment its used in.

Even if the ceiling is 2.5M, i would still install an ip rated accessory regardless.
 
Aico 3000 Range
This official sponsor may provide discounts for members
Advertisement - Content continues below

Reply to fixed items in bath rm in the Electrical Forum area at ElectriciansForums.net

Advertisement - Content continues below
Advertisement - Content continues below

Electrical Forum

Welcome to the Electrical Forum at ElectriciansForums.net. The friendliest electrical forum online. General electrical questions and answers can be found in the electrical forum.
Advertisement - Content continues below
Top Bottom