Discuss Help with wiring in the UK Electrical Forum area at ElectriciansForums.net

Rico1987

DIY
Reaction score
0
Can anyone help with some advice with the below wiring. I am wanting to change an outdoor light from its current rather old looking lamp to a dusk till dawn light. Nothing fancy the wiring for this just a live/neg no earth. However when I have taken the casing off for the current light the wiring is as below. Any advice as to why the live has an earth sleeve over it and why there are so many wires? There is only one switch to turn it on/off and the current light is also just a live/neg by a block connector. I'll obviously get a multimeter to it before fitting the new light just after some advice. I thought the wiring picture below the connector was just backward however the live/neg on the current light fits in to the correct marking.Thanks in advance.
20191124_152405.jpg
 

Attachments

  • 20191124_152405.jpg
    166.5 KB · Views: 22
At a guess, I would say the sticker is upside down.

You can’t know for sure without a proper voltage detector, but I am assuming the following.

The 2 reds together are permanent live. You need to isolate those at your consumer unit.
One black is the neutral. The other black is the switches live and should have a bit of tape on it or something to distinguish it from the other black.
 
Looks like the 2 red wires are permanently live, one of the blacks is a switch wire and should be sleeved red, the other is neutral, without testing it isn't possible to say which is which.
The earth sleeved wires will be the cpc.
I would hazard a guess that the label below is upside down

@littlespark beat me to it
 
first of all you need to see which is live looking at that fitting loopin left next to that live neutral on the end earth .just to let you know the label up side down.and im on me head,lol.
 
At a guess, I would say the sticker is upside down.

You can’t know for sure without a proper voltage detector, but I am assuming the following.

The 2 reds together are permanent live. You need to isolate those at your consumer unit.
One black is the neutral. The other black is the switches live and should have a bit of tape on it or something to distinguish it from the other black.

That would probably make sense. Thank.you for taking the time to reply.
 
Can you show a pic of the old fitting, the part that plugs onto that connector.


Having re looked at it again I think it appears that the sticker is the wrong way round I've tried to line up the connectors shown in the picture from the original light and they connect to the 2x black wires in the blocks where on first view looked like it slotted in to the earth wire. Makes sense now. Just need to work out which is the live black wire now. Thanks
 

Attachments

  • 20191124_191024.jpg
    61.6 KB · Views: 24

Reply to Help with wiring in the UK Electrical Forum area at ElectriciansForums.net

Similar Threads

Hello, disclaimer: this is DIY and I am rather ignorant about electrical works. I just moved into a new rental apartment and i wanted to connect...
Replies
11
Views
479
Hi all. Yesterday I wired in my 3 phase compressor to run off our 53kva generator. I just need to know which colour cable is for which phase as...
Replies
13
Views
2K
I hope someone can help with this as I'm stumped. My landing hallway ceiling (2016-build house) has two rose pendants which I've attempted to...
Replies
7
Views
382
Hi I've been planning to fit an outdoor junction box at the front of my house to hide a large brickwork hole and properly house the wiring...
Replies
9
Views
839
Hi, I need some advice on the wiring for a new ceiling light. I have taken down the original light, and I'm left with the wiring in the image...
Replies
6
Views
1K

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

Electrical Forum

Welcome to the Electrical Forum at ElectriciansForums.net. The friendliest electrical forum online. General electrical questions and answers can be found in the electrical forum.
This website was designed, optimised and is hosted by Untold Media. Operating under the name Untold Media since 2001.
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock