Wetroom Store - Network Wetroom Suppliers
This official sponsor may provide discounts for members

Discuss Hi all..and my first problem is... in the The Welcome Forum area at ElectriciansForums.net

S

splinter65

Welcome to ElectriciansForums.net - The American Electrical Advice Forum
Head straight to the main forums to chat by click here:  American Electrical Advice Forum

Hi everyone on this forum. I am not a qualified sparky having worked for BT for over 25 years before taking early retirement. Anyway enough about me, my problem is how do you remove an existing MCB from a crabtree starbreaker con unit. I can see how they must slot over the top and then clip into the busbar but they seem firmly fixed when it comes to taking one out. I need to replace a 16amp mcb for a 20amp (radial circuit) one.Any advice welcome!
splinter65
 
uHeat Banner - Forum Discount Available
This official sponsor may provide discounts for members
Aico 3000
Mr Mark Sparks

Mr Mark Sparks

-
hello and welcome
look below the mcb there is either a metal or plastic cilp put a flat scerwdriver inand pull up uo the driver the bottom of the mcb will come forward
 
A

acat

  • Thread Starter Thread Starter
  • #3
Welome to the forum hope the above solves your problem




Chris
 
S

splinter65

  • Thread Starter Thread Starter
  • #4
Thanks Mark. Job done! Cheers cat for the welcome. Like they say `it`s easy when you know how`..

Splinter 65
 
Last edited by a moderator:
A

Andy Smith

  • Thread Starter Thread Starter
  • #5
HI splinter65 welcome glad you done the job now fully trained at that aspect :);)
 
D

Dave

  • Thread Starter Thread Starter
  • #8
Hello and welcome to our community...:)
 
CK Tools :) The professionals choice when it comes to Electrical Tools
This official sponsor may provide discounts for members

Reply to Hi all..and my first problem is... in the The Welcome Forum area at ElectriciansForums.net

Instyle LED Lighting Specialists UK
This official sponsor may provide discounts for members
Top Bottom