Hi all..and my first problem is...

[splinter65]

Hi everyone on this forum. I am not a qualified sparky having worked for BT for over 25 years before taking early retirement. Anyway enough about me, my problem is how do you remove an existing MCB from a crabtree starbreaker con unit. I can see how they must slot over the top and then clip into the busbar but they seem firmly fixed when it comes to taking one out. I need to replace a 16amp mcb for a 20amp (radial circuit) one.Any advice welcome!
splinter65

 

[Mr Mark Sparks]

hello and welcome
look below the mcb there is either a metal or plastic cilp put a flat scerwdriver inand pull up uo the driver the bottom of the mcb will come forward

 

[acat]

Welome to the forum hope the above solves your problem




Chris

 

[splinter65]

Thanks Mark. Job done! Cheers cat for the welcome. Like they say `it`s easy when you know how`..

Splinter 65

 

[Andy Smith]

HI splinter65 welcome glad you done the job now fully trained at that aspect

 

[Guest123]

Welcome along.

 

[Mac]

Hi and welcome to the forums

 

[Dave]

Hello and welcome to our community...