How to draw an automatic control project

[dodo41]

Hello to everyone.
I made a circuit, but I do not know how to draw a project for it.
(German Norm) or (American norm)
Relay = R1
I entered the A1 terminal of the sensor cable from I24. (+ 24V.)
I entered the A2 terminal of the sensor cable from C24. (0 V).
I entered the cable from OSSD1 to the A1 terminal of the relay. (+ 24V.)
I entered the cable from relay C24 to A2. (0 V).
I input the I6 cable to the terminal 11 of the relay. (+ 24V.)
I entered the cable from the 14th terminal of the relay (R1) to the I6 terminal (NO contact) of the Pilz module.

 

[pc1966]

I am not sure what you mean by "draw a project for it".

What you illustrate appears to be a relay base, and what the exact function is would depend on the type of relay that is plugged in.

On the side it shows the schematic diagrams for the two supported options, either a change over relay (SPDT) or an opto-isolator.