Lighting with pirs and emergency

[Kelec1]

Hi, been tasked with this circuit. its being wired in singles onto kliks.
have a good idea, but dont want to mess it up.

 

[tazz]

Singles will make the job easier, feed to klik box, pir to switch switch feed, unswitched feed off klik to Em supply

 

[Outspoken]

Wire it as any lighting circuit with E-Lights.

The switch line goes to the PIR (requires Neutral)
The permanent live goes via a keyswitch

Personally I would two plate this so that the feed to the PIR for the switch line is linked off the E-Switch so that when operated it kills the power to the normal lights and thus makes it simpler to assess the brightness and operation of the E-Lights.

Here is a simple graphical example of my comments for you..

 

[Kelec1]

Should have mentioned there is no klik box. wired direct into klik roses

 

[MDJ]

Hi, been tasked with this circuit. its being wired in singles onto kliks. View attachment 19283
have a good idea, but dont want to mess it up.

Okay well what's the question? seems very basic wiring to me!

 

[Guest55]

take it from MDJ , he's the forums expert on "very basic"

 

[MDJ]

take it from MDJ , he's the forums expert on "very basic"

Na na na na na, (sticking tongue out)

 

[Adam W]

If you want to leave the normal lights on when you test the emergencies you'll need to take a separate emergency feed from the keyswitch, ie 3 core. Otherwise you can take a twin feed as far as the PIR, take the live feed from the permanent live (A) and take the switched live back into the L terminal. You'll need a 3 core between the PIR and emergency fitting, then twin to the rest.

 

[Kelec1]

the circuit has a k/s incorporated. would I run perm and switched to em, and link both em, with separate live to normal lights

 

[Outspoken]

the circuit has a k/s incorporated. would I run perm and switched to em, and link both em, with separate live to normal lights

Did you look at the drawing I posted on the second post above, that answers your questions..