OP
alan
I understand it is a TT system. If the main earth cable is not buried it need only be 4mm
If buried should be 16mm.
Table 10c OSG.
If buried should be 16mm.
Table 10c OSG.
Discuss No R1 on ring main? in the Periodic Inspection Reporting & Certification area at ElectriciansForums.net
Reply to No R1 on ring main? in the Periodic Inspection Reporting & Certification area at ElectriciansForums.net
Similar Threads
Hi,
I did my first EICR on a TT system today and the Zs was a lot higher than Ze+R1+R2 on everything.
Zs was around 3.5 ohms on all of the ring...
Hi guys.
Having a weird problem in a house that has suddenly happened.
One half of the ring main has 240ish volts (fluctuates of course), and...
Hi All,
Had a weird one this morning during an EICR.
Testing a ring final circuit in a 2 bed flat… kitchen was on a separate ring. With only the...
Please advise what I should test / check next.
My usual qualified electrician who did all of the work here is in Ireland for 4 weeks and not...
After fixing a few CPC related issues on a ring final I got the following results
L-L = 0.47
N-N = 0.47
CPC-CPC = 0.69
R1+R2 Tested at 0.31...
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
This website was designed, optimised and is hosted by Untold Media. Operating under the name Untold Media since 2001.