- Reaction score
- 25
So I am going to fit a spot light using 1.5mm weatherproof flex with a 3amp switched fcu from a 32amp ring main. Just thought I would make sure This is correct before I start ?
- Thread starter Ashley-Joseph
- Start date
-
- Tags
- spotlight
Discuss Spotlight in the UK Electrical Forum area at ElectriciansForums.net
Share this page
OP
- Reaction score
- 25
Thanks I think the light comes with 0.75 flex standard tbh.
- Reaction score
- 8,190
Pretty standard set up
Could use 1mm flex to safe a few pennies
Could use 1mm flex to safe a few pennies
Reply to Spotlight in the UK Electrical Forum area at ElectriciansForums.net
Share this page
Similar Threads
Hi guys, newbie posting!
Does the following sound ok...
Existing circuit:
SOCKET on a ring -> spur to SWITCHED 3A FCU -> SWITCH -> hardwired FAN...
Hi,
I have just replaced an old rewireable fuseboard with a 10way consumer unit with rcbo's fitted.
The issue i have is that when i connect one of...
Hello all,
I'm replacing a 3-bulb spotlight with a standard BG ceiling rose but upon connecting, the light won't turn on; the problem is, I can't...
Hi All, thanks in advance for any guidance you can provide. I will of course turn off everyhing at the consumer unit before doing anything.
I...
Hi
Customer has an extractor fan that’s inside the shower cubicle high up on the wall. The extractor fan has no form of isolation and is wired...
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
Electrical Forum
Welcome to the Electrical Forum at ElectriciansForums.net. The friendliest electrical
forum online. General electrical questions and answers can be found in the electrical forum.
This website was designed, optimised and is hosted by Untold Media. Operating under the name Untold Media since 2001.