Y
YTSOxford
hi all, just need 2 pick some brains over earthing. Have come to a secxond fix this week, and have to hook up this fancy whirlpool tub. The whole job is nearly complete, builders are just finishing and making good, when i realise the tub has a fly green and yellow on one of the motors. Obviously this must be to bond the jet outlets etc, but where would be the best place to bond???
Main water & gas bonding in place and all circuits on 17th ed board, so no green and yellow was run into the bathroom. Should bond to the taps, although this is that crap flexible hosing stuff, or should i just connect it to the baths junction box/ circuit box; but why hasn't this been done already???
As i sed, they have made good, so can't go drilling and knocking. Appreciate all comments, event those sacastic ones. Many thanks......
Main water & gas bonding in place and all circuits on 17th ed board, so no green and yellow was run into the bathroom. Should bond to the taps, although this is that crap flexible hosing stuff, or should i just connect it to the baths junction box/ circuit box; but why hasn't this been done already???
As i sed, they have made good, so can't go drilling and knocking. Appreciate all comments, event those sacastic ones. Many thanks......