• IMPORTANT: The thread you're reading / posting in, could be in a DIY electrical advice area. Please be aware of your local laws. You're not allowed to provide advice to, or seek advice from, DIYers and fellow professionals in some States, Countries, Countys etc with regards to some types of electrical installations or repairs. Keep that in mind. If it's against the law where you are - always get a professional electrician in to carry out the works instead of doing it yourself. The forum will not be held responsible for any outcome of any applications of any advice sought from it.
Electrical2Go - Online Electrical Supplier
This official sponsor may provide discounts for members
Advertisement - Content continues below
Advertisement - Content continues below

Discuss Wiring terminal block for induction hob in the Electrical Appliances Forum area at ElectriciansForums.net

Welcome to ElectriciansForums.net - The American Electrical Advice Forum
Head straight to the main forums to chat by click here:  American Electrical Advice Forum

Hello...I need to rewire a terminal block for zanussi induction hob zei6840fbv
Can someone help please. ImGe attached

68B33F97-B247-43B7-91ED-AC39728772B1.jpeg
 
Advertisement - Content continues below

buzzlightyear

-
Arms
Esteemed
what does it say in the instruction book .how to wire it .it should show you on the plating or the cover or .

All electrical connections should be made by a qualified electrician. • The appliance must be earthed. • Before carrying out any operation make sure that the appliance is disconnected from the power supply. • Make sure that the electrical information on the rating plate agrees with the power supply. If not, contact an electrician. • Make sure the appliance is installed correctly. Loose and incorrect electricity mains cable or plug (if applicable) can make the terminal become too hot. • Use the correct electricity mains cable. • Do not let the electricity mains cable tangle. • Make sure that a shock protection is installed. • Use the strain relief clamp on the cable
 
Last edited:

Spoon

-
Mentor
Arms
Esteemed
Hello...I need to rewire a terminal block for zanussi induction hob zei6840fbv
Can someone help please. ImGe attached
Welcome to the forum mate.
If you are rewiring it, how was it originally wired up?
 

telectrix

-
Mentor
Arms
Esteemed
what he says^^^^^. connection diagram will be in the manual. having looked that up.it states that the hob comes with cable already attached, an electrician with a test meter should be able to identify which terminal is which.
 

telectrix

-
Mentor
Arms
Esteemed
L to teminal #1 linked to #2. N could be #4 or #5. that's an educated guess. ( and pirate can do the earth.:p:p:p.).
 
there should be a linking bridge the same as the neutral to link the live side as if you leave that out only two of the hobs will work
 
SuperlecDirect - ElectriciansForums.net Electrical Suppliers
This official sponsor may provide discounts for members
Advertisement - Content continues below

Reply to Wiring terminal block for induction hob in the Electrical Appliances Forum area at ElectriciansForums.net

Advertisement - Content continues below
Top Bottom