mount

Search the forum,
Recent contents Top users
  1. A

    13amp Double Socket with plug presented at 45 degrees- do you know a supplier ??

    Hi This question was asked some years ago on this forum but the link to the supplier is no longer active. I am looking for a Wall Mounted 13 amp double socket that could be mounted on a narrow kitchen upstand that would normally not allow the use of moulded plugs. as i see it there are three...
  2. B

    In line relay required

    Good morning all. I'm looking for a suitable solution to this problem. I am installing a heating system in a property which is to be controlled zonally via the Honeywell evohome Problem is that the relays for the evohome can only handle 5a maximum and one of the heaters is 1400w - almost 6a...
  3. D

    Corrosion proof flush mount back boxes

    Hi all, After many years of replacing corroded metal back boxes on older buildings here is a solution that really should make its way to the uk: box lid Picture - More Detailed Picture about type 86,single gang wall mount junction box, outlet wall switch box,enclosure,flush box, plastic back...
  4. E

    Pics of Sonos wall mount setups

    Hi all, After some guidance with a Sonos setup. Looked for a few decent multi room media setups for our home and the Sonos products look right up my street. My question really is how have people run the supplies to the units. I want to give the impression that the units are completely wireless...
  5. J

    SPDT Switch

    Hi everyone I'm New here. I need to add a a couple of 12V ACC plugs into my ute via a 4 pin micro relay. It will be switched via the key so the plugs turn off as pernormal with the key. BUT, I was wanting to mount a SPDT (Single Pole, Double Throw) switch into the circuit somewhere so I can turn...
  6. M

    Need Schuco ground mount system

    We need to extend a Schuco MSE210 ground mount system and this product is discontinued. Anybody got any old stock they want to sell or any ideas before we get it fabricated ourselves. Thanks
  7. jason121

    Ground Mount

    Does anyone know were I can hire a vibrating post driver ?? thanks
  8. S

    Ground mount systems

    Can anyone recommend a good ground mount system for a 50kW install? Either single or double row of panels, pile driven ideally and the array area is very flat as it used to be a paddock. Looking at the Tric system Wagner do but thought that you guys would have some good recommendations.
  9. back_ache

    Surface mount low profile LED ceiling light recommendations

    Hi, I am lighting up a bathroom, for most it I am using some nice IP rated scolmore warm-white led downlights. I have an additional need for a surface mount light where there is not a ceiling void, I was thinking of a low-profile LED light but am find it hard to find a nice mid-range device...
  10. M

    6 Module Monopole Mount

    We have a system installed ~2006 with 8 x 130W modules on a single pole mounting structure made by Unirac. We are now looking to expand the system, but I'm struggling to find anyone who can supply a similar (or identical) mounting system which would hold 6 ~260W modules. Wind and Sun can do a...
  11. S

    RCD Protection Units For En-Suite

    Hi Guys, I'm new to the forum and just wanted to say hello and if I may, ask for any help and advice as it would be really appreciated. I'm aware that the latest electrical regulations state that circuits within a bathroom/shower room/en-suite, need to have RCD Protection. However, where would...
  12. O

    besa boxes surface mount fittings

    Hey up, I've got to fit 2 2x58W fluorescent fittings surface mount no access from above but the fittings have besa mounts on rear. Cable will be in plastic conduit. Will the besa boxes support the fitting weight? Do you put 4 boxes on the ceiling then hold the fitting on these using the lids...
  13. S

    Low flat roof mount needed please.

    I need a ballasted flat roof mounting where the highest part is around 300mm from the flat roof. Looked at Tric F box but that finishes about 430mm. Can anyone recommend me one? Thanks Matt
  14. jaydee81

    flush mount consumer unit

    can anyone recommend a decent flush mount consumer unit only needs to be 6 way with main switch only gonna end up with 4 circuits so using rcbos
  15. S

    Surface mount T&E through plant room ?

    Hello, I've been asked to run in a new circuit for a dishwasher in a school staff room. I've planned a 20amp / 2.5 T&E radial feeding a 13amp fused connection unit and fixed equipment connection point. The planned cable run includes running across the ceiling of the plant room (2/3...
  16. G

    best boards

    can anyone recommend a good cu for top entry ?
  17. M

    Ground mount systems in PV sol

    Hi Folks. trying to design my first ground mount system in PV sol, can it be done? If so how. I can only get it to put stuff on buildings!!cheers in advance Andy oh, and why when I post on here all of a sudden my return button doesn't work so I can't do paragraphs!!!
  18. S

    Recommend a Ground Mount system

    Hi Can any one recommend a decent 4Kwp Ground Mount System 2 x Rows of 8 Portrait easy to install look forward to your replies
  19. M

    Where can I get more of this ground mount frame ?

    Hi We went to a bankruptcy auction this week and picked up over £3K of solar brackets, rail, inverters, etc etc for £200. ONLY bidder !! :hurray: There were five of these ground mount frames :- Does anyone know who makes them or what they are called or who stocks them . Thanks
  20. A

    Help with ID of surface mount dome lights

    Hi, I am trying to ID the make of some dome shape panel lights. They would be pre 1976 but could be still made. They are a shallow dome with a chrome ring around the bottom that matches the curve of the lens. The lenses have rings around the inside. The size is about 35-45 mm. I was a welder for...
Tiling Forum

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

UK Tiling Forum
This website was designed, optimised and is hosted by untold.media Operating under the name Untold Media since 2001.
Tiling Advice
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock