• Please checkout this (ad-free) update post I've done on a spare blog. Feel free to bookmark it and check everynow and again for update if ads are pissing you off. Always feel free to ad-block them for now though if you want. I'll let you know when you can disable the ad blocker again, only if you want to see the ads. They should look nice and neat in the end.
Questions and electrical advice in the Electric Underfloor Heating Wiring - Electric Underfloor Heating Wiring Advice by Electricians Forums is Expert Advice from a community that started in 2006. We are the largest electric underfloor heating wiring forum. And our advice is second to non. Discounted under floor heating for all provided by uHeat.

Some popular forums: Electrical Forum - Electrical Wiring, Theories and Regulations - Periodic Inspection Reporting & Certification - Electrical Jobs

A B C D E F G H I J K L M N O P Q R S T U V W X Y Z #
  • Sticky
All trade will get an extra discount. See information here...
Replies
0
Views
4K
What’s the best setup for a system that has a heating system with existing radiators but a wet underfloor heating system is being added to a new...
Replies
3
Views
166
Calculate the temperature rise in a system consisting of six conductors carrying 1500 amperes each at 132kV, insulated with XLPE, and spanning a...
Replies
2
Views
136
m having a bit of an issue that is proving difficult to resolve. For 2 years I have been having no problems with my setup. I have a 3 zone house...
Replies
1
Views
249
  • Question
Hello All, I have Adept TW02W wifi Thermostat - does anyone know how to reset it?
Replies
1
Views
339
I have a loose wire underfloor heating system I am installing for a client ideally they would like the UFH to continue into the down stairs loo...
Replies
4
Views
504
I have a customer that has 3 heating mats under the tile. This was installed a while back and a relay was used. I measured a 21 amp draw for all...
Replies
4
Views
1K
Hi guys/gals, Had a message from an old customer from my old firm whos having problems with their stat. They have 3 electric ufh using the same...
Replies
1
Views
725
Hi, I'm getting renovations done to my home, including an existing extension which already has wet underfloor heating. We are moving a kitchen...
Replies
16
Views
3K
Hello Guys, I was wondering if any of you nice chaps could lend me some advice. So I have an open vented heating system with a 3 port valve...
Replies
9
Views
2K
Hi, I'm looking for some help with an UFH thermostat that I can't find the model of. All I can see is that it's made by Rehau. Installed roughly...
Replies
2
Views
2K
  • Question
Hi. I have very old underfloor heating with thermostats. I'd like to replace the thermostats with timer/thermostats if possible. The current...
Replies
7
Views
1K
I recently wired a heating system with a UFH8 manifold and an unvented cylinder.... easy. Well it threw up a few problems. Initially I had the...
Replies
3
Views
2K
Hi. I’ve recently had installed a manifold (including zone valve and pump) for the newly installed Wet UFH in my extension. The system is split...
Replies
14
Views
2K
Morning all, I'm about to embark on some home renovation and the kitchen is the first target. We are looking at making it bigger, all in the room...
Replies
37
Views
9K
I've had a electrician say i need to come from fcu but its going on a dedicated rcbo do i need fcu
Replies
3
Views
1K
Hello, The floor boarding has been stuck down with adhesive and screwed down also with extra metal washers. Someone has now told me it is not a...
Replies
12
Views
2K
Hoping someone knows of a product that can be used for a single UFH zone with 3 heads and two radiators zones. The heat miser UH4 can use zone4...
Replies
0
Views
847
  • Question
We are replacing the flooring for the whole ground floor - it is a circa-2000-build house with concrete slab. We're taking the opportunity to put...
Replies
0
Views
924
What are your thoughts on using electric underfloor heating as a primary heat source in a church? It's a typical old church building - a couple...
Replies
23
Views
3K
All of the UFH thermostats that I have ever fitted have had the air temperature sensor integrated into the hard-wired wall mounted programmer...
Replies
4
Views
1K
Hi I have a heatmiser uh4 wiring centre and a grant vortex combi condensing oil boiler, doing the heat and HW in a small cottage, the room stats...
Replies
1
Views
972
Hi, I would like some advice on using Tado with electric underfloor heating to ensure it is I have Tado contolling my boiler and radiators...
Replies
6
Views
5K
  • Question
Hi all, Am planning controls of some existing underfloor electric mats that have previously had inadequate controls fitted. So far have tested and...
Replies
0
Views
584
Hello, could any one recommend a Rf thermostat . It’s for elderly customer so reliable and simple are main requirements. Thanks
Replies
2
Views
1K
Long story short, I forgot to mark where my cables were prior to installing laminate. I accidently skimmed the side of a cable for one of the...
Replies
2
Views
1K
Evening all, Doing a bit of forward planning for an extension with possible electric ufh. i Have worked out room will need 25m2 split between 2...
Replies
7
Views
2K
  • Question
I'm a total amateur so apologies in advance for any stupid question. I have a white box with a tiny timer button which you can turn from 1 minute...
Replies
1
Views
1K
  • Question
I am a DIYr. I have a gas fired underfloor heating system installed about 12 years ago. The controllers are Uponor C35 and thermostats T35...
Replies
7
Views
3K
  • Question
I have electric underfloor heating. The thermostat lights on but there's no heat felt via the floor. The termostat is a Time Guard UFPT7. What...
Replies
1
Views
2K
Hi everone can anyone advise me on two things I'm having underfloor heating fitted and want to run it on my economy 7 Has anyone managed to do...
Replies
36
Views
10K
  • Question
I have two hive zones. One for the house and one for the UFH in the kitchen. When I boost the UFH from the thermostat or the Hive app the light...
Replies
2
Views
2K
Hi guys just in the process of wiring up a 3 zone Drayton jb with 3 zone wireless heating controls. My question is as it stands at the moment...
Replies
10
Views
3K
Evening, im going to try and explain the heating system im currently wiring, I have most of it wired up, there’s just a few bits im not sure of...
Replies
2
Views
2K
Hi. We have moved into a new build house in Feb this year that has infrared underfloor heating and an economy 7 tariff. For info we also have...
Replies
5
Views
2K
Hi guys! I bought a pool heater online and this Is the wiring diagram that comes with It. Can someone please tell me if this Is possible? From...
Replies
15
Views
2K
At a rewire today, client has decided he wants underfloor heating all through his house. This is what will be heating his house. Downstairs it’s 4...
Replies
15
Views
3K
Ringmain fed by 32A mcb on split board protected by rcd,I'm spurring of ring feeding a underfloor heating system rated at 9A ,I know I can fit a...
Replies
5
Views
2K
Whist looking up something unrelated in section 701, I noticed reg 701.753 Stating that underfloor heating wire in a bathroom must have an...
Replies
10
Views
3K
hi ALL, I wired an electric UFH mat in a lounge, mat company said I can use this size mat for one programmer, it was at its max, I wired it...
Replies
8
Views
3K
Hi guys Looking for some advice with regard to wiring a heating system. Starting a new build next week and have little if any experience with...
Replies
6
Views
5K
Post a New Thread / Question

New Posts (Please Reply)

This website was designed, optimised and is hosted by Untold Media. Operating under the name Untold Media since 2001.
Top