Search results

  1. M

    UK Hypervolt/EV Charger showing falling voltage ?

    Have spoken, they confirmed input voltage fine during scheduled charge, but drops in manual charge
  2. M

    UK Hypervolt/EV Charger showing falling voltage ?

    Yes, RCbo The bump charge is an octopus term that refers to charging outside their scheduled night time charging (when costs might be more expensive )
  3. M

    UK Hypervolt/EV Charger showing falling voltage ?

    Hi all Looking for some wisdom I installed a Hypervolt charger (the most recent model which is no longer available for direct purchase fr Hypervolt) It’s on a smart octopus setup Works perfectly fine on scheduled charge But when doing an Octopus ‘bump charge’ , Hypervolt says voltage falls...
  4. M

    UK Three phase supply into single phase board

    Might be one with three pole rather than 4 pole - didn’t think of that - thanks But still looks they have almost all the load on one phase, with a 63A mcb for the entire house. (Which could be argued is not my problem, if I’m only quoting for solar work completion)
  5. M

    UK Three phase supply into single phase board

    Hi I popped round to quote for ‘ finishing ‘ a solar install started by a company rhyming with Bird of Polar . The house has a three phase supply, but it looks like someone has taken the three live tails into board not designed for three phase (albeit with a three pole switch). They’ve only...
  6. IMG_2030.jpeg

    IMG_2030.jpeg

  7. M

    UK What would you do?

    Thanks. As mentioned I tried to find why the power was not going to sockets. They cables appear to run up to the ceiling, and into a loft that I can’t get into (it’s a bungalow with very low roof truss) the one part of the loft I can get into doesn’t have anything I can see related to problem...
  8. M

    UK What would you do?

    The neighbours are doing that to start with and contacting gas board - as no paperwork left And I did think all the above sorted before looking into problem circuit Ps from What I understand the previous consumer unit was a fuse type board, and was ‘upgraded’ to allow a solar install
  9. M

    UK What would you do?

    I couldn’t find any listing of the solar company on NiCEIC or NAPIT. All kinds of wrong really and does need to be properly sorted. I’m also wondering if I can take over solar monitoring (it’s a solar edge system which I am certified on) to prevent further ‘monitoring, by them
  10. M

    UK What would you do?

    I was asked to see why a set of sockets weren’t working in the house (which appear to be a ring circuit based on breakers) There was no power on either leg in any of the sockets. Cables appear to run down from loft, which is totally inaccessible unless you are a small child in any of the rooms...
  11. IMG_0795.jpeg

    IMG_0795.jpeg

  12. M

    UK Earthing back to neighbours in terrace?

    Thanks all. Im back there tomorrow, and hopefully be able to trace back earth cable.
  13. M

    UK Earthing back to neighbours in terrace?

    Thanks - yes have asked if they can change to TNCS - 4-6 week lead time apparently To sign off the work, I’d need to have visual site of adequate earthing and not just an ok reading - I don’t think Im being too ---- about this am I?
  14. M

    UK Earthing back to neighbours in terrace?

    Been asked to do some rewiring, and have said needs upgrade of consumer unit really Main question is regarding earthing - Zs reads at 0.45 ohms (which suggests at TNS) But cannot see where earth cable goes to from old fuseboard. There is no earth to fuse carrier or cable to fuse carrier in...
  15. M

    Live incomer is earth cable wrapped in brown tape?

    I guess a proper discussion with client is due. Of note, the reason why I didn’t look as thoroughly as I should have first time is that there was full electrical NICEIC branded installation certificate posted up next to board downstairs . Will need to check when that was signed off and if they...
  16. M

    Live incomer is earth cable wrapped in brown tape?

    Any practical solutions that don’t involve cutting new holes to run a new cable ?
  17. M

    Live incomer is earth cable wrapped in brown tape?

    Yes, I’m guessing same, but will give update when get chance to go to property - which I won’t now until Monday as client not available until then
  18. M

    Live incomer is earth cable wrapped in brown tape?

    Thanks for prompt response Neutral probably the same yes but can’t confirm yet There’s a lot of other dodgy and messy wiring in there, but the rest would reasonably easy to resolve in the consumer unit Im going back to property today to look at a bit more, as I wrongly assumed there would be...
  19. M

    Live incomer is earth cable wrapped in brown tape?

    Hi I wonder if anyone has any useful thoughts on this. Client wants me to redo consumer unit but doesn’t want disruption to fabric of building. I’ve attached pic - looks like original wiring was a 16mm earth to the live incomer . The meter box is >20m away. I guess cable is cable but 16mm...
  20. 67C65FFB-CDAE-4F0B-98DC-9A37E5AA2688.jpeg

    67C65FFB-CDAE-4F0B-98DC-9A37E5AA2688.jpeg

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electric Underfloor Heating Electrician Courses Heating 2 Go Electrician Workwear Supplier
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

Advert

Daily, weekly or monthly email

Advert