I usually put the socket at a height of 25-30 cm from the floor, and the switch at the level of 90 cm so that it is convenient to reach with a hand from the bed.
I would advise not to make a meter transfer if the new smart meter fits in the same place. The main thing is to connect the wires correctly, then everything will work as it should.
I would suggest to call the tester wire to understand where exactly power is lost, and then decide whether to remove the carpet or look for another problem.
I have encountered a situation where meter tails are placed in the wall more than 3 meters without an RCD. Usually, DNOs do not allow tails of this length without protection, and I did this: put tails in a metal tube or armoured cable to avoid the requirement for RCD. If tails go in ordinary PVC...
I faced the following problem: The easiest way to install a normal single-phase electricity meter is directly after the feed at the input of a small DB. I plugged it into a standard board, output the readings manually, or put the model with remote data capture if it is important to record. This...
I put these mats and I can say that they will be very warm without normal heat insulation from the bottom, not your room. I also thought to save money and try something else, but in the end, I bought the usual recommended insulation boards. I did not find cheap and effective alternatives, except...
I had a similar situation when the old import/export counter did not show correct data after rollover. I contacted the supplier (I don’t have Octopus, but the principle is the same), and they also offered to replace the counter with a smart meter, which was the only solution they officially...
I recently played God of War (2018) on the PlayStation and can recommend it if you haven’t tried it yet. I liked the plot and the fight, the game lasts for a few days. Also I did The Last of Us Remastered - good story and interesting atmosphere. If you want something easier, I sometimes run...
I had the same table lamp, and I went through this problem. At first, I replaced the tube itself: it was brighter, but it is dim again after a couple of turns. Then I took the body apart and checked the ballast - the plastic was warm and there was a slight squeak. I put a new electronic ballast...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc