Recent content by kendo57
-
UK RCBO indicator , short circuit or earth fault.
Anyone know of an RCBO manufacturer, apart from Chint,that includes an indicator in the RCBO to indicate if the trip is a earth fault or an overload.- kendo57
- Thread
- circuit earth fault indicator overload rcbo short short circuit
- Replies: 2
- Forum: UK Electrical Forum
-
UK Unable to remove front cover
Exactly my thoughts, I've advised the customer to have the consumer unit replaced, definitely DIY job. You see some things lol. Thanks for input, all the best.- kendo57
- Post #11
- Forum: UK Electrical Forum
-
UK Unable to remove front cover
The consumer unit is on a campervan, and there is a 30ma RCD and two mcbs inside. The owner had just bought the van and wanted a safety check to ensure all was ok. I've never seen the likes before.- kendo57
- Post #9
- Forum: UK Electrical Forum
-
UK Unable to remove front cover
Drilled holes through front cover.- kendo57
- Post #7
- Forum: UK Electrical Forum
-
UK Unable to remove front cover
This consumer unit is in a camper van customer wanted an Edict doing for his own piece of mond- kendo57
- Post #6
- Forum: UK Electrical Forum
-
IMG_20230506_110224~2.jpg
- kendo57
- Media item
- Comments: 0
- Category: Electrical Videos
-
IMG_20230506_110318~3.jpg
- kendo57
- Media item
- Comments: 0
- Category: Electrical Videos
-
UK Unable to remove front cover
What would you guys code this. Unable to remove front cover on consumer unit, due to cables passing through the side of the cover.- kendo57
- Thread
- cover front remove unable
- Replies: 11
- Forum: UK Electrical Forum
-
Distribution Board
Just found an MCG board, 565mm by 405mm. Not sure of the quality, but needs must I suppose.- kendo57
- Post #5
- Forum: UK Electrical Forum
-
Distribution Board
Sorry didn't give enough info on my previous thread. Looking for an 8 way (8 three pole mcb's) three phase dist board. Max height 600mm, Max width 410mm. Cheers.- kendo57
- Thread
- board distribution distribution board
- Replies: 6
- Forum: UK Electrical Forum
-
MCCB Zs
Think the rcd add on is the only option, DNO said Ze is what it is, helpful as usual- kendo57
- Post #4
- Forum: UK Electrical Forum
-
MCCB Zs
Got a Ze of 0.6 ohm on a TN-S. Circuit protected by a 250 amp mccb with an operating Zs of 0.073 ohms. Any ideas what I can do? Any advise much appreciated.- kendo57
- Thread
- mccb
- Replies: 3
- Forum: UK Electrical Forum
-
UK 35mm Downlight
Cheers, used the quickwire like you said only just fits, but did the job. 1592932629- kendo57
- Post #10
- Forum: UK Electrical Forum
-
UK 35mm Downlight
Quicwire see.s to tick all the boxes. Cheers.- kendo57
- Post #5
- Forum: UK Electrical Forum
-
UK 35mm Downlight
Anyone know of a junction box that will go through a 35mm hole. I have to install e.ergency downlights. Cannot gain access above ceiling. Cheers- kendo57
- Thread
- access anyone cannot ceiling downlight downlights install junction through
- Replies: 11
- Forum: UK Electrical Forum
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
