One thing I also find is that you can get higher earth loop readings when doing a non trip test due to the R.C.D. So doing the dead test gives you a better idea of what your actual resistance is.
I made a dispenser from conduit parts but the bushes gave way after very little use, so that went into the skip.
I do own both of the other types and still have the problem of the cable wrapping itself up, I think the cable makers need to make the cardboard on the outside of the reel bigger and...
Have just done an install of LED downlights and used a dimmer made by aurora which replaces the existing dimmer however did also use dimmable LED lamps. So no need to put the extra halogens on as it is made for dimming LEDS. (AU-DSP400X)
A neighbour of the mother in law was a sparks and also colour blind, however there are different types of colour blindness and i would suppose if you were told often enough as an apprentice(whats one of those i hear you ask) what colours what, you would pick up the difference. Also the old...
Did he use the circuit tester that IDEAL make think its called a sure tester. Which will put a signal on to the circuit being tested, then you can trace it with a hand held meter. When it gets to the cause of the fault it gives a signal. Seem to remember them being £420 or pay a bit extra and...
Was doing work on a farm a while back. The farmer asked me to have a look at a pendent in one of the barns, when we got to said light he turned it on. At which point it literelly sparked into life and also caught alight much to his amusement. All I could was stare in horror as he told me " it...
Did try auto strippers when i had to wire panals for baggage lines bloody things broke on 2nd cable, and insulation was that tough i had to use the stanly to strip the ends down.
Just had to send my ethos in for repair/ thumping as failed calibration test on earth loop values, all other functions o.k. only had it 3 years. Guy that did testing did warn me off from buying the new megger as they seem to have been alot of problems with them. Will just have to wait for cef to...
Do'es anyone out there use a rhino label printer, and if so are they any good? As sometimes i find you can have very little room to mark up ciruits, plus if all you have at hand is a biro you can garantee you will smudge what you have written in your best spider out of inkpot writing.
Did some lights last year but were in york stone. But client went with square fittings made by aroura. These were easyer for builder to cut out for as they had more of a lip to cover up the hole underneath. Got builder to fit drainage pipe (100mm) in ground to about half a meter then ran in...
Was doing work at a farm many years ago. Had just started to drill hole through wall by some existing submains, when the boss came in and said he would do it. Didn't think I should in case i went through one of the submains. Needless to say as I was working elsewhere when all the power went off...
I suppose the time involved might take a couple of hours to swop over to two clocks. And then the customer has to remember to alter them for GMT & BST.
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc