Hi guys, this feels like a bit of a "simple simon" question and despite having fitted hundreds of down lights, don't think I've done this before...
Customer changed existing 12v MR16 lamps for MR 4.5w leds. Didn't change the transformers though and is suffering from the leds flickering when on...
Hi there.
I own a 1985 VW T25 Autosleeper and am based in Manchester.
The 12v system works perfectly, with a new 90ah leisure battery and split charging system recently fitted.
My problem is that when I hookup on 240v some of the 12v appliances stop working, but the internal plug sockets...
Neal Andrews
Thread
12v
240v
campervan
electrical work
electricians vans
issues
not working
system
van
vehicle
working
Hiya!
A friend has 27 12V downlights in his kitchen/dining area and wants to change them for LED to save on his electricity bill. I've not had any experience of these lamps and was wondering whether anyone on here could answer 2 questions, the first being, are they any good? In terms of light...
Hi.
Has anyone ever inspected 12v electrics in a dwelling i.e a beach hut / cabin or similar? Basically the electrics are all run off a 12v leisure battery. There is a small solar panel that tops up a battery for a 12v fridge. The beach hut can be slept in so apparently needs an electrical...
New here so I say hello.
Some advice on car 12v please.
I want to fit a dual volt and amp meter in my dash, and have one with the appropriate shunt. My expectations are, when the engine is off it will show the state of the battery. When the engine is on it will show the active volts and...
Hi
Built a sliding door wardrobe and want to finish it off by having a 3 metre strip of RGB leds along the top edge of track to shine down on the glass doors. Is it safe / ok to NOT use the power adapter the light came with (laptop type supply) and instead have them powered from a 12v LED...
Hi,
I have a spotlight rail with four MR16 bulbs (12v) on it. It has an integrated transformer.
The replacement needs to be of similar size i.e. length approx 90cm and run with low-voltage MR16 bulbs.
There seems to be a plethora of these spotlight rails that use GU10 240v bulbs etc, but I...
Hello all....
I have recently been asked to put in 9 LED 230V downlights, which I have done.. all working fine. The reason was the old 12V halogens only had 2 of the 9 working and the customer said everytime she replaced a bulb they would either not work at all or only last a few days/weeks...
Hi all
Was asked to fit two transformers for shop window display.
there was 8 12V down lighters in total split into two circuits and both switched through a timer,
The owner wants to replace the 8,12V dichroic MR16 bulbs with 12V MR16 LED 1.8w bulbs.
The reason he wants to replace the dichroic...
Speedy38
Thread
12v
bulbs
downlighters
driver
led
mr16
polarity
transformers
I've just noticed an odd problem.
I have 2x 12v downlighters in a small room.
On the same circuit, in my living room there are 12x 12v downlighters connected to two dimmable transformers.
The attached load is well within the limits of both the transformers and the dimmer switches that control...
Hi All,
I'm hoping for some advice on a confusing subject! I have just changed all my down lights in my bathroom as the old ones were rusty and not working due to the transformers being faulty. The old lights were bog standard with no face or anything to protect from splashes (even above...
Hi guys
I have just bought a use hydraulic oil pup that runs from a 12v motor
I didnt have a 12volt battery to try it with but i had a 240v to 13v 5amp
Inverter i wired it up via the solenoid but just got a few clicks from the
Solenoid
I then ran a 30ft cable from my 12v battery in my...
Hi,
Sorry tried to post this in diy forum but it wouldn't let me for some reason.
I have purchased a 12v ICON ECO 30S fan to replace an old 12v Manrose fan.
Link to icon fan
http://www.tlc-direct.co.uk/Technical/DataSheets/Aidelle/iCON_SELV.pdf
The old fan was connected with Twin &...
sharpey79gfc
Thread
12v
advice
airflow
extractor
extractor fan
fan
needed
wiring
Hi,
I am just putting a load of CCTV camera up, and also several IR floodlights.
The floodlights, 12v, jus wondering if I can put them on a timer?
I have seen these 12v din rail timers on eBay for less than £10, I was thinking of getting a couple, feeding the timer with th 12v from the CCTV...
Hi! Can anyone help me, I am working on an invention.. I want to put a programmable timer between a 12v battery and a 12v appliance.... Is this possible with off the shelf stuff on ebay.. I am trying to create a prototype product from an idea that I have had, obviously I can't say exactly...
First of all, I have minimal knowledge of anything electrical so please forgive my ignorance!
My problem is that I bought a portable heated handwash unit from eBay which is designed to go in a van. It's 12v 15a and 180w.
You can see the unit in question here: Handeman for motor vehicles |...
Mattg
Thread
12v
adapter
appliance
mains
output
power
supply
transformer
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.