Video of issue:
Hi
I’ve noticed a humming from my fuse box when my nightly off-peak water comes on.
When I first moved in I had a similar issue, albeit louder / more high pitched. An electrician replaced the contactor at the time.
It might be worth noting that that little grey box (I think...
I have wired a heating system with 8 heating control zone valves and 1 on water,all work ok,problem is it has heating pump which comes on with heating valves but also with hot water zone valve,how can I separate the heating pump to only come on with the 8 valves.
Hi there,
I have an air source heat pump with a few issues:
1. It gets stuck on defrost mode. When it goes to defrost, it gets stuck and ends up becoming an air conditioner in the depths of winter (fun). I suspect this may be a faulty valve (or what ever reverses the coolant) getting stuck on...
just checking the regs 753.411.3.2 which state i need to use a conductive mesh connected to the CPC of the circuit.
I am installing a flexible heating mat from Warm Up in a kitchen and i dont see any mention of the mats needing a conductive mesh needing to be installed??
HI all,
got a holiday let that wants to control heating from their home as people leave it on etc.
setup is s plan upstairs HW and heating(rads) , with stat up there for heating
downstairs two zoned UFH, bathroom and Lounge
ive priced up the polypipe stuff, new center and stats and its...
I need to provide heating for a converted warehouse, approx 150 - 180 sq meters. (1 large square room)
The space will only needed to be heated for a couple of hours in the morning, I was thinking possibly fan assisted to get the temp up quicker, any suggestions?
Thanks
Judd
recently installed underfloor heating in my glass room 16m2 the under floor heating is 1800w which im told is 160w per square metre anyway issiue is its not reaching the temprature im calling for in fact ive never got it above 22 degree c it can take about 8 hours just to reach 19 any help please
Doing a periodic...previous certs show full re wire in 2011...so...the old colour mains tails were obviously just tat they wanted rid of...only 16mm main earth jointed in the board
But then...along comes the plumber/heating engineer and decides he'd rather be a comedian
Trying to install Drayton wiser hub r...
The backplate has previously been wired and is as in picture. Attached.
The diagram is in instructions as how it needs to be. Attached.
Which wired need to go where..
Please help
Is it a requirement to provide overload protection to a central heating pump rated at 2.77amps?
I’m kinda under impression that an almost 3 amp pump jamming will get rather hot.
I mentioned this to the heating installer who has requested we just installed 2 x isolators for the pumps through a...
Been asked to look at an electric UF heating system.
As yet it is laid but no connected and no supply is present.
There are two mats at 1600w so total 3200w, 14A.
My intention is to run a feed off a 20A RCBO via a 20 DP isolator to the thermostat.
Run in 2.5 T&E, clipped direct total <10m...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.