Currently reading:
Multimeters

Discuss Multimeters in the Electrical Tools and Products area at ElectriciansForums.net

If you take a look on ebay ther'es 1 on there at the minute for £58 + £12 carriage, it's a US firm but a good saving.
If you want a uk firm then I find the Instument Centre good to deal with & very reliable.
Address: 44 Argyle street, Newport, Gwent, NP20 5NE. Tel: 01633 853803.

Hope that helps mate.
 
Last edited by a moderator:
I carry 3, a cheap maplin clamp meter £12.99 small and not a bad meter, a maplin gold also cheapish and not a bad meter and a fluke 73 III series.
 
Oops, sorry mate: Messed that 1 up did'nt I lol.
Go to ebay & put the item number in the search box: 220794632020. Listed as £58.07 + £11.84 carriage.
 
Last edited by a moderator:
Wow this has run quickly!

I carry a Fluke 87 in my tool case for every day fault finding, this is an old version mind, about 20 yrs old.
I also have an 8060A like Lenny pictured of the same vintage.
I have my trusty AVO9, unfortunately could not get a good version of an 8 when I needed it, so went for the 9.

Day to day I also carry a Fluke 337 clamp, a KEW 1710, a Fluke Voltstick, a Fluke 1653B, a DiLog DL6507 leakage clamp & my LEME HEME Analyst 2060 single phase power clamp.

Still shopping for more kit though, LCR meter is a must, will look into one of those ESR meters, looking for a portable DSO, probably 4ch, a Ductor, & 3Ph power analyser, and an earth clamp tester for now!
Have come unstuck on a couple of jobs recently and could have paid for the kit in the jobs easily!
 
A Neon ? wash your mouth out:tounge_smile: Seriously though I carry what's called a Junior Testoscope in my pocket all the time, which is an expensive Neon. Only thing is we're not actually supposed to use them any more for H/S reasons.
When I started in the trade a Neon & AVO were the only thing you carried for general fault finding, if you wanted the Megger you had to tell the Boss why & sign for it & in all the years i've used them i've never had a shock through a Neon.

I never had a shock through a neon either (unless the toerags I worked with swapped the resistor for a lower rated one!), and still use one. the H/S concerns are utter rubbish. went to a job once where a light would not turn off, soon diagnosed a nailed switch wire (rentokil had been doing woodworm treatment upstairs) .Took the bulb out and went over the nailheads with a neon, took about 5 mins to find it! (TRS- no earth wire) pulled the nail, repaired the cable and out the door.
Phil
 
Know what you mean mate, i've allways been the same. I've got test equipment for all sorts of stuff lol, the ESR meter by the way is a good investment. I bought the Blue ESR meter from www.electronicrepairguide.com in kit form. Simple to build / test & a lovely bit of kit.
You'll have to tell me 1 day the sort of stuff you spend your days fault finding on.
 
I never had a shock through a neon either (unless the toerags I worked with swapped the resistor for a lower rated one!), and still use one. the H/S concerns are utter rubbish. went to a job once where a light would not turn off, soon diagnosed a nailed switch wire (rentokil had been doing woodworm treatment upstairs) .Took the bulb out and went over the nailheads with a neon, took about 5 mins to find it! (TRS- no earth wire) pulled the nail, repaired the cable and out the door.
Phil

Nice 1 mate, I used to love the Neons supplied to the Electricity board boys, easy to see even in strong sunlight. Made by a company called NEO but it seems they don't exist any more, did see an apprentice get a shock through a Neon once but the idiot was useing it in the Rain so deserved it lol.
 
Wow this has run quickly!

I carry a Fluke 87 in my tool case for every day fault finding, this is an old version mind, about 20 yrs old.
I also have an 8060A like Lenny pictured of the same vintage.
I have my trusty AVO9, unfortunately could not get a good version of an 8 when I needed it, so went for the 9.

Day to day I also carry a Fluke 337 clamp, a KEW 1710, a Fluke Voltstick, a Fluke 1653B, a DiLog DL6507 leakage clamp & my LEME HEME Analyst 2060 single phase power clamp.

Still shopping for more kit though, LCR meter is a must, will look into one of those ESR meters, looking for a portable DSO, probably 4ch, a Ductor, & 3Ph power analyser, and an earth clamp tester for now!
Have come unstuck on a couple of jobs recently and could have paid for the kit in the jobs easily!

If you want a 4 channel portable scope, I would go for a Fluke one if you are willing to spend around 3K :rolleyes2: same for the power analyser......
 
grant,
Thanks, it is Fluke I am looking at.
My power analyser is "now" Fluke, just before they bought the company for the technology!
The Techtronix scopes are quite good, but I am used to Flukes as this was what I had supplied when I was using one regularly.
I will spend the £3k if I have to!
 
Perhaps we should start another thread ''What's Test Kit do you have to hand'' !! Otherwise this thread is going to get side tracked from time to time...

I must admit, i'm a collector of test equipment, and have a pretty extensive collection, some of it i'll probably never use again, and realistically should be sold on. lol!!!
 
Perhaps we should start another thread ''What's Test Kit do you have to hand'' !! Otherwise this thread is going to get side tracked from time to time...

I must admit, i'm a collector of test equipment, and have a pretty extensive collection, some of it i'll probably never use again, and realistically should be sold on. lol!!!
i can see a 'during the war' speech coming on..:wink:
 
my dad was in it. 39-45. best time of his life, he used to say.
 

Reply to Multimeters in the Electrical Tools and Products area at ElectriciansForums.net

Electricians Tools | Electrical Tools and Products

Thanks for visiting ElectriciansForums.net, we hope you find the Electricians Tools you're looking for. It's free to sign up to and post a question yourself to find a tool or tool supplier either local to you, or online. Our community of electricians and electrical engineers will do their best to find the best tool supplier for you.

We also have a Tiling Tools advice from the worlds largest Tiling community. And then the Plumbers Forums with Plumbers Tools Advice.

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

This website was designed, optimised and is hosted by untold.media Operating under the name Untold Media since 2001.
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock