Recent content by Yozza19
-
Does anyone here drive a Citroen Berlingo with the 8" touch screen?
1.4 and 1.6 were superb vans newer 1.5 is awful we’ve had 3 fully serviced 69 plates suffer engine failure less than 60k on each- Yozza19
- Post #29
- Forum: Auto Electrician Forum
-
Does anyone here drive a Citroen Berlingo with the 8" touch screen?
Make sure you constantly cheak the ouil and service 6 months Real bad engine and oil burners.- Yozza19
- Post #27
- Forum: Auto Electrician Forum
-
Why doesn't my Security Light work?
Activate the pir and test voltage on outgoing side of pir- Yozza19
- Post #4
- Forum: UK Electrical Forum
-
UK Fire alarm question
Ld2 is circulation areas + high risk anywhere with electricity or gas usually- Yozza19
- Post #4
- Forum: UK Electrical Forum
-
3 phase problem after spark did 5 year safety inspection
I don’t think the clamp is the source of the problem it would of been in a dam sight worse condition if it was I’d say a loose connection that has eventually caused the internals to short To be honest the whole design of l2 to be loaded up like that is a sh!t show Another 3 phase db instead...- Yozza19
- Post #51
- Forum: UK Electrical Forum
-
Wylex 3 phase board fitting.
Never use metal blanks on a vertical mounted installation as I learned the hard way few months back doing a strip out on a old bupa building everything labeled up incorrectly (as I know know )removing the db cover to cheak it was isolated and one of them metal blanks slid down and landed...- Yozza19
- Post #22
- Forum: UK Electrical Forum
-
UK Replacement Unvented Boiler installed - Do I need a new Electrical Box?
No metal closing lid would be the obvious one I’d of thought🤷♂️- Yozza19
- Post #9
- Forum: UK Electrical Forum
-
MX Pro 5 fire alarm panel programming
On hockiki protocol and advanced Mc pro pannel you need the programming tool to set the address for each device this then can be auto learned at pannel and type relevant txt into the address You also can do the set up for any I/0 units you require eg for mag locks ect- Yozza19
- Post #6
- Forum: UK Electrical Forum
-
power from kiosk to house
No unfortunately it does not work like that large run of expensive cable- Yozza19
- Post #2
- Forum: UK Electrical Forum
-
C-TEC fire alarm compatibility
The best way (not the cheapest ) Is to install a small single loop addressable pannel eg advanced or c tec xfp and 9 no sun rail zone monitors This would be a compliant system- Yozza19
- Post #35
- Forum: UK Electrical Forum
-
Reliable LED floodlights
Anything that is outdoors and needs to last look no further than colingwood lighting Eg https://www.tradesparky.com/lamps-and-lighting/fittings-led/floodlighting/cwood-ifl20bx40-floodlight-4000k-200w- Yozza19
- Post #7
- Forum: Electrical Tools and Products
-
Outside light turns on by bathroom light.
Are you sure you haven’t connected onto the bathroom light sw instead of the loop terminal- Yozza19
- Post #9
- Forum: UK Electrical Forum
-
Locator Tool - Loft use
Pop a small hole with your terminal we’re it will be required and pop a lazer pointer through the hole- Yozza19
- Post #7
- Forum: Electrical Tools and Products
-
-
How reliable are you finding smoke detectors..whos do you prefer
We fit thousands of aicos every year very few are actually fualty less than 1% and most of theese are environmental factors We did fit circa 1500 fire angel units on a contract they were specified by the client and the failure rate was astronomical- Yozza19
- Post #4
- Forum: UK Electrical Forum
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
This website was designed, optimised and is hosted by Untold Media. Operating under the name Untold Media since 2001.