Hi all, sorry if this question has been asked before.
I am currentlly using Formfill's free software to do my certificates, but was think of buying the Pirform sortware of the elecsa site, is/has anyone used this, feedback would be much appreciated, thanks.
spraymate1
Thread
anyone
becsa
certification
competent
cps
easycert
elecsa
person
pirform
scheme
software
using
I have an emergency lighting system that a place i have worked before is planning to install and were asking me to advise and spec the job. i think that the best and least disruptive method of install is to feed all emergency lights off local lighting circuits. seeing as this is the case what in...
sparks1653
Thread
advise
becsa
certification
competent
cps
emergency
emergency lighting
initial
lighting
lights
person
scheme
system
testing
Hi, Would I need to be part of a self certification scheme if i was not to do any domestic work? Just commercial based work? General maintenance in commercial/industrial premises. Also could i carry out pat testing without scheme? PIR im assuming i would need to be under scheme? I would have...
Thomas123
Thread
becsa
certification
commercial
competent
cps
don't
industrial
part
person
scheme
self
without
Just a question,
have the PIR, Minor works certs changed in the new bs7671 green books changed or are they still the same.
I havnt got a green regs book yet as im not working in the industry yet, but i was just doing some study and wondered if they have changed.
Thanks
Justin pearson
Thread
becsa
bs7671
certification
competent
cps
person
scheme
could someone please tell me whether you need an electrical certificate if you rent your house out to someone, if so which type and how much roughly would it cost, ten circuits in the consumer unit.
sounds a bit of a daft question i think but just want to clarify it. thanks
Hi I am an electrician with my NVQ level 3, 2382, and 2391 qualifications and am looking to start out on my own. I am looking to get Part P registered as I have always been employed before and not required it. As well as passing the course do I need to register with 1 of the competent person...
wkdsi27
Thread
becsa
certification
competent
cps
part
part p
person
scheme
Have been to look a job were a certification is needed for previous work. The owner has sold their house but has no certifcate for the electrical work that was carried out about a year & a half ago. They have tried to contact the company without any success.
This is now holding up the move as...
Hi all
I'm just after a little advice i have been asked to install a 100a dp isolator between a customers CU and meter, to provide isolation of the whole property.
they have had some work done in the past as the CU is relatively new and seals on main fuse have been removed..
If i was to...
S.t.one
Thread
advice
becsa
certification
competent
cps
install
installation
isolator
person
scheme
HiCan anyone help me with regards to filling in a niceic part p cert with regards to the part were it concerns tt.This is on page 2 I need help with the parts electrode resistance ra , is this the measured ze result I have taken ?And also method of measurement ? Also what is the maximum ze for a...
Simon81
Thread
becsa
certification
competent
cps
person
scheme
system
tt system
Need you're help on issuing a cert. In september last year i did a PIR on a property and all inspection and test results were well within spec.Since then I have recently installed a new CU and on testing i now have a N-E IR fault on the lighting circuit. Out of goodwill and no charge I have...
hi everyone i went to a flat and did a periodic for rental. I then did remedials of which included a board change requiring an installation cert. Can I ask do i nedd to supply a periodic and an installtion cart with the same values on them i am thinking yes if people can advise please.
Hi, I need some help and this is my first time on here so please forgive me if this question has been repeated many times. Im looking to convert my house and let rooms individually so need to have some mains wired smoke and heat detectors installed and a periodic check, however ive had various...
millymolly35
Thread
becsa
certification
competent
consumer
consumer unit
cps
edition
periodic
person
requirements
scheme
unit
I have been working underneath a fellow electricians umbrella until recently, but never really paid much attention to the testing side of things,(i have since done the 2392 course) I am now on my own and recently fitted a new consumer unit for a customer and i am wondering what is required on...
Robbs
Thread
becsa
certification
competent
cps
person
required
scheme
hello, it looks like the JIB will be issuing me a new JIB Approved Electrician card within the next few weeks. My question is - My neighbour asked me if I would be able to rewire his house for him. I told him that I would be glad to and we then agreed on a price. I was wondering if it was...
wireman357
Thread
becsa
certification
competent
cps
house
person
requirements
rewire
scheme
some help please on my 1st tt installation.i am rewiring a property and was wondering about the certs.when i am filling in measured ZE on some ccts they may be higher than the Max ZE,do i just fill in as usual?comments box? advice muchly appreciated.:confused:
Hi I was wondering if the sockets/lights in say a kitchen are on the same circuit as the rest of the downstairs sockets/lights does it still come under a special location (need to be able to self certify or get the council in) or would it be minor works as it is the same circuit as the living...
still learning.
Thread
becsa
certification
competent
cps
part
person
scheme
self
special
Hi To all..First post so please be gentle..
I am a time served sparky and have recently passed the 17th IEEE..
I am currently working in a hotel, installing inverters to act as a variable speed drive on
circulation pumps...This involves fitting new D class 3 pole Mcb's and rewiring throughout...
red1
Thread
3 phase
becsa
canada
certification
client
competent
cps
install
issue
person
phase
provide
scheme
working
yourself
Hey all,
I have my Bachelors degree in Electronics & Communication engineering from India.I have 12 years of experience in machine (PLC based machines)and plant maintenance in India.I moved to UK and looking for a job in industrial sector .What certification I have to do to get a job in UK as...
avis
Thread
becsa
certification
competent
cps
electric
electrical
person
scheme
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc