G

GarryJ1990

Evening,

I am trying to get a signal from my Sky Q Box in 1 corner of a room to a TV on the opposite wall.
I have ran a CAT 6 cable between the points and terminated RJ45 ends on to each end.
I have tested cable with LAN tester and proves fine.
I have tried the below link for which I had hoped to transmit HMDI using the CAT 6 cable but can not get it to work.

Is there a reason for this? Any help would be appreciated - I am an approved Electrician but not so up to speed with Home Automation.

Below is the link of the ends I have tried.....

https://www.ebay.co.uk/itm/2pc-1080...45deba8516e5d7a12983|ampid:PL_CLK|clp:2334524
 
I think the £6.69 including postage for the pair says it all.
 
  • Like
Reactions: GarryJ1990
Have you got TX and RX the right ends?

There's a video on Youtube suggesting the adapters are only good for 15mtrs
 
  • Like
Reactions: GarryJ1990
  • Like
Reactions: StephenRowley
Easy to install, and gives you flexibility for an extra TV in kitchen and bedroom etc. Obviously, the same channel on all of the TVs. Very easy to install too.
 
  • Like
Reactions: StephenRowley

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electric Underfloor Heating Electrician Courses Heating 2 Go Electrician Workwear Supplier
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

Advert

Daily, weekly or monthly email

Thread Information

Title
HDMI - CAT 6
Prefix
N/A
Forum
Home Media Centre Forum
Start date
Last reply date
Replies
7

Thread Tags

Tags Tags
hdmi

Advert

Thread statistics

Created
GarryJ1990,
Last reply from
pirate,
Replies
7
Views
2,607

Advert