Evening,

I am trying to get a signal from my Sky Q Box in 1 corner of a room to a TV on the opposite wall.
I have ran a CAT 6 cable between the points and terminated RJ45 ends on to each end.
I have tested cable with LAN tester and proves fine.
I have tried the below link for which I had hoped to transmit HMDI using the CAT 6 cable but can not get it to work.

Is there a reason for this? Any help would be appreciated - I am an approved Electrician but not so up to speed with Home Automation.

Below is the link of the ends I have tried.....

https://www.ebay.co.uk/itm/2pc-1080...45deba8516e5d7a12983|ampid:PL_CLK|clp:2334524
 
Easy to install, and gives you flexibility for an extra TV in kitchen and bedroom etc. Obviously, the same channel on all of the TVs. Very easy to install too.
 

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Green 2 Go Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses Heating 2 Go
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

Advert

Daily, weekly or monthly email

Thread starter

Joined
Location
Ayrshire, Scotland
If you're a qualified, trainee, or retired electrician - Which country is it that your work will be / is / was aimed at?
United Kingdom
What type of forum member are you?
Electrical Engineer (Qualified)

Thread Information

Title
HDMI - CAT 6
Prefix
N/A
Forum
Home Media Centre Forum
Start date
Last reply date
Replies
7

Thread Tags

Tags Tags
hdmi

Advert

Thread statistics

Created
GarryJ1990,
Last reply from
pirate,
Replies
7
Views
2,552

Advert

Back
Top