Very helpful mate, thanks.
At the end of the day I'm fitting fire rated downlights which I think is sensible and gives me peace of mind.
Fitted LAP before and never had a problem. I acknowledge there's better brands available but it is what it is.
To be honest, I just assumed they would for safety purposes due to insulation in ceiling and to stop the spread of a fire should it occur. It would of been my inclination to purchase fire rated downlights if I'd designed the job.
If its not a requirement then the original downlights they...
Hi, got a job to connect up some new spotlights in a conservatory. Roof has been replaced and plaster boarded. I'm assuming insulation has also be installed.
Originally the client purchased Enlite Spryte non-fire rated IP44 LED downlights, however I thought that they should be fire rated as...
Yes it is in good condition, I just wondered whether it would been tested to the same fire rating standards as a newer metal clad board, and that by indicating C3 it would be evident that it is an older board and would not be something we would install now. I will most likely not code it unless...
I'm pretty sure these are compatible, same as whats in the board now, not too expensive:
Eaton EAD32BH30C 32 Amp 6kA Type B 30mA Memera RCBO - Edwardes -...
Looking for some advice as im fairly new to EICR reporting, although have passed 2394/95 and have carried out a couple of straight forward reports.
Firstly, on a EICR I have carried out for a family member I have found an old MEM memera 2000 metal clad consumer unit, over 8 years old. I was...
That's what I was hoping to hear!
Basically I need to replace the light in the bathroom with an IP fitting as the property is being let out. In the course of starting to replace the light I found the problem. I'm not altering the installation as such, just repairing the faulty cable.
Best EV Chargers by Electrical2Go! The official electric vehicle charger supplier.
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc