Recent content by EbolaSideRoom

  1. EbolaSideRoom

    Wylex MCBs then and now...

    Thanks for replying. Are you able (and willing) to share an image of said writing? TIA
  2. EbolaSideRoom

    Wylex MCBs then and now...

    That clears it up nicely. Thanks happysteve!!!
  3. EbolaSideRoom

    Wylex MCBs then and now...

    Thanks for replying, but I’m a little confused: are the readily available NHX prefixed MCBs compatible with the older NSB on the same busbar/in the same enclosure? TIA
  4. EbolaSideRoom

    Which screws do you use...?

    A builder friend introduced me to screwshop.co.uk a couple of years ago; I haven’t bought CSK wood screws or red plugs anywhere else since. I do like the Orbix screws though. The CEF web site had some good prices on tubs of them recently.
  5. EbolaSideRoom

    Wylex MCBs then and now...

    A client has a Wylex NHRS RCD main switch CU with MCBs prefixed NSB. I don’t use or see a lot of Wylex kit; are the newer NHXL prefixed MCBs compatible with this ’board?
  6. EbolaSideRoom

    Pick up trucks...

    I used a Nissan Navarra for 30 months to work out of and the more I used it, the more I hated it. I didn’t mean to roll it in the snow (and I lost a packet on it) but I was much happier working out of a Peugeot Expert for the next 5 years whilst I paid it off.
  7. EbolaSideRoom

    To torque or not to torque that is z question

    Post edited
  8. EbolaSideRoom

    Working in (north) London

    We did a job in Kensington years ago and I spent longer moving the van and feeding meters than I did working. Still managed to pick up two tickets, from the same “attendant” who was cycling round the same patch. After the second one I asked him if that meant I could just stay there and he said...
  9. EbolaSideRoom

    House consumer unit to garage consumer unit

    I’ve just re-read Charlie’s question and noticed he mentions Cat5 SWA.
  10. EbolaSideRoom

    House consumer unit to garage consumer unit

    Forgive my stupidity please Charlie, but are you agreeing with, or questioning, Alban Moffitt’s assertion that Cat5 run in duct alongside SWA @230V must have insulation rated “to the same as voltage as power”?
  11. EbolaSideRoom

    To torque or not to torque that is z question

    I always use a torque driver to tighten to the upper limit of the manufacturers tabulated Nm for the specific terminal. I use the same brand of RCBO board most of the time so it’s not tricky to remember, and if I go ever go too far above it the accessory usually shows some sign of damage pretty...
  12. EbolaSideRoom

    Best RCBO consumer unit

    Late to the party as ever.... OP, if you’re still looking for opinions, I have to thank you for mentioning SBS. I’d never heard of them before. I’ve been banging on for a while that a neutral bus bar adjacent to the line bus bar is surely the way forward. So good for you. And if I were your...
  13. EbolaSideRoom

    Klein Tools Are they worth the extra money

    My local CEF showed me the full range of Klein hand tools and to be fair it was massive. They chose to introduce to the UK market the huge pliers first, which was probably a mistake as every CEF I’ve been in since has loads of them gathering dust. I found some small needle nose pliers and some...
  14. EbolaSideRoom

    American FF tripping RCD

    Might be a little behind the curve here, but is it a Type AC RCD/RCBO, and is it worth trying a Type A instead? Just a thought. Bash me if I’m being silly.
  15. EbolaSideRoom

    Radial vs Ring in a standard 3 bed

    I have to agree here. I’m not at all a fan of RFCs, but there are circumstances where it makes more sense to use one instead of a radial. And I also agree that one 16A or 20A radial Circuit for general use Sockets per Floor is plenty for the average dwelling.

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

Tags

advice aus cable circuit course earth electric electrical electrician hello led light lighting lights looking new please question rcd socket supply switch testing training wiring
This website was designed, optimised and is hosted by Untold Media. Operating under the name Untold Media since 2001.
Electrical Blog
Tiling Forum UK
Tiling Tools for Beginners
Electricians' Talk
Tiling Advice Live
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock