If the forum is NOT loading any colour PLEASE CLICK HERE.

Recent content by Km1777

K
New circuits into plastic consumer unit

Yes Napit
- Km1777
- Post #5
- Sep 26, 2024
- Forum: UK Electrical Forum
K
New circuits into plastic consumer unit

Thanks . I was thinking similar to what you’ve said 👍
- Km1777
- Post #4
- Sep 26, 2024
- Forum: UK Electrical Forum
K
New circuits into plastic consumer unit

Morning everyone . Question regarding wiring of new circuits into plastic cu . I’m wiring an extension on a property soon . The consumer unit is under the stairs and it’s plastic it’s all rcbo Wylex board in good condition with a few spare ways . Probably the last of its generation before we...
- Km1777
- Thread
- Sep 26, 2024
- circuits consumer consumer unit new plastic unit
- Replies: 4
- Forum: UK Electrical Forum
K
Garden supply on PME system

Thanks for that guys I was more thinking about difference in potential between the tub and wet paving flags . The tub is plastic . But it’s the heater if class 1 that’s the issue isn’t it in the event of a broken pen
- Km1777
- Post #8
- Feb 19, 2024
- Forum: UK Electrical Forum
K
Garden supply on PME system

That link won’t load . Who said it was class 2
- Km1777
- Post #4
- Feb 19, 2024
- Forum: UK Electrical Forum
K
Garden supply on PME system

Evening everyone . Currently looking at pricing a job up . It’s a hot tub supply . Outside socket with a few spare ways in an outdoor cu . 10mm armoured cable on 45 amp mcb . To outdoor consumer unit . From there a 32 amp hot tub circuit and an outdoor socket all in armoured . The question is...
- Km1777
- Thread
- Feb 19, 2024
- garden pme supply system
- Replies: 7
- Forum: UK Electrical Forum
K
ZE on tnc-s system

Thanks I re tested this morning as I had other bits to finish off . I tested three times and it was 0.30 every time . It may have been my leads not being zeroed that caused the higher reading yesterday .
- Km1777
- Post #8
- Feb 4, 2024
- Forum: The Welcome Forum
K
ZE on tnc-s system

Thanks It’s a 100amp Main fuse not a rural area it’s on a min street . The pfc is 0.6ka so happy with that . All Zs readings are below max values . I’m just use d to seeing lower readings on a tnc-s system
- Km1777
- Post #6
- Feb 3, 2024
- Forum: The Welcome Forum
K
ZE on tnc-s system

Evening everyone . I was changing a fuse board today . Everything tested out fine and good . Until I measured the Ze which is on a tnc-s system . The result was 0.36 ohms now I know the max value for tncs is o.35 ohms . What would you guys do in this event call the dno or accept the result ...
- Km1777
- Thread
- Feb 3, 2024
- system
- Replies: 7
- Forum: The Welcome Forum
K
Gas bond outside 600mm

I see that point . I’m going to have to run a new cable into the meter then at my cost. more than likely as I’ve finished the job now
- Km1777
- Post #11
- Oct 31, 2023
- Forum: Electrical Wiring, Theories and Regulations
K
Gas bond outside 600mm

Yes it’s extraneous And yes it continuous I know it needs bonded it’s just the fact that if it’s bonded at the boiler it will do the same job as it would if it’s bonded in the gas meter .
- Km1777
- Post #7
- Oct 31, 2023
- Forum: Electrical Wiring, Theories and Regulations
K
Gas bond outside 600mm

Still isn’t wrong though is it if you think about the reason why it’s bonded it doesn’t matter where it’s bonded at it
- Km1777
- Post #5
- Oct 31, 2023
- Forum: Electrical Wiring, Theories and Regulations
K
Gas bond outside 600mm

Metal
- Km1777
- Post #4
- Oct 31, 2023
- Forum: Electrical Wiring, Theories and Regulations
K
Gas bond outside 600mm

evening everyone . Quick question here I’ve recently took over a job that a friend of mine first fixed it’s a 3 bed semi house rewire. I don’t usually do this but he’s recently folded he’s business because of a job he’s got so no longer registered. I know he’s workmanship is to a good standard...
- Km1777
- Thread
- Oct 31, 2023
- gas gas bond outside
- Replies: 10
- Forum: Electrical Wiring, Theories and Regulations
K
Consumer unit rcbo spd price

boiler change isn’t relevant I was just thinking about it because I’ve recently had mine done and was wondering why no one bats an eyelid at paying top dollar for a days work for boiler swap . When a consumer unit swap is our equivalent. Anyway thanks for the replies was just trying to get a...
- Km1777
- Post #8
- Jul 6, 2023
- Forum: UK Electrical Forum

Best EV Chargers 2025

Best EV Chargers by Electrical2Go! The official electric vehicle charger supplier.

OFFICIAL SPONSORS

These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc