Hi, Me again,
I found the retaining screw at the top end.
There was a small push on cover over it. Very cleverly done but very difficult to see.
Now for the real work.
Good luck everyone
J.
Hi,
I have a Dimplex ERC20 heater that's not working.
I tried to open the panel but having removed the wheels I found and removed the 2cover retaining screws but it's held tight at the top and I can't for the life of me release it.
I think it should be a push up and it will come off but it won't...
Thanks, Mainline & Ferg,
I had a little slack on the pipe and could put the connection on loose with my hand. I then marked the wall and undid the connection and drilled the holes. I was able to reconnect and fit the shower. I was also acle to get spanners on the connection and tighten so I'll...
I've installed a Mira SE shower. My query.
The instructions indicate a vertical rising or a falling pipe connection. I connected in a horizontal direction.
As the shower connector swivels I can't see a reason to have it only in a rising or falling type connection position, except in the...
Thank you Telectrix, I'll use that.
Is it a requlation to use two isolating switches, one for each piece, or a personal preference. Asking around I believe it's done.
1582827832
I meant a personal preference because of distance between hob and ovens
Indeed, quite recent, but there's no certification required when there's no connection to the mains, I appreciate the need for the public to be sure the person is a registered contractor/qualified electrician, which incidentally doesn't stop people doing shoddy work. besides and my daughters...
Hi All,
I'm a retired spark and separate double ovens and hobs (induction) weren't around in my day. I did mostly power station work after a few years domestic. My daughter asked me to wire in her double oven and hob, however the rating on the double oven says, Oven A .77kW per cycle and similar...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc