door

Recent contents Top users
  1. D

    Garage door external key switch

    I have been asked recently if I could fit somebody an external key switch for there garage door - As at the moment they have to go through there house to push the available buttons on the unit inside the garage. I told them this is possible, but my query is finding a suitable IP rated key...
  2. L

    Routing wiring near garage door springs

    I’m running an EV charging system in a garage it’s a 50 amp circuit 6 gauge wire can be Romax or in conduit Romax is cheaper but not an issue either way it’s easy access. My concern is placement to make the run the shortest and easiest will be about six inches above the hardware and springs...
    • Lowlysubaruguy
    • Thread
    • door garage routing screwfix wiring
    • Replies: 1
    • Forum: UK Electrical Forum
  3. Neptune

    Door bell wiring - advice please

    I am planning to replace battery powered door bell with one of these mains powered sets: https://www.cef.co.uk/catalogue/products/64350-wired-transformer-doorchime?gclid=f2ccabfbe9b010f462c9c947a329f18c&gclsrc=3p.ds&msclkid=f2ccabfbe9b010f462c9c947a329f18c A couple of questions please: 1. I...
  4. L

    Door access control kit & Wiring

    Hi all, Currently wiring 3 new flats and have questions about the door access. Theres one main door to the flats which will have an intercom outside aswell as a keypad w/proximity tags to unlock the door. Ive never installed or wired door access before and have been looking online at door...
  5. A

    correct wiring for oven grill door microswitch?

    Hi, I was wondering if anyone can help me, I'm trying to work out which two of these three microswitch tabs to use. I have a Hotpoint Hug52 oven and the grill won't stay lit. I checked the thermocouple and it looked in a poor state so I have installed a new one. I took a photo of the wires on...
  6. C

    Heavy duty DIY next door possible cause of oven tripping circuit?

    Hello, new here! Would greatly appreciate some input. I'll first say I intend to get an Indesit technician to take a proper look tomorrow, but I'm curious. A couple of hours ago I tried to switch the main oven on as usual - the oven is only 2-3 yrs old - and a spark came from behind the...
  7. V

    Next door neighbour mains spurred, pre-meter off my main fuse!

    Semi-detached next door house mains supplied from my property pre-meter off main fuse. I cannot get a smart meter as main fuse cannot be pulled by non DNO electrician. This arrangement has been confirmed as not a revenue dodge (ie running feed to garden shed, extension etc). We confirmed the...
  8. not wired

    Door bell issue

    I have salvaged the door bell operation from an old M&S intercom system which doesn't quite function as it should. When you make normal contact on the door bell button, the chime doesn't produce a clear and reasonably prolonged sound. Its muted (fuzzy) and only engages for a split second and...
  9. R

    Paxton Net 2 door access control

    Hi all, Our door access is being upgraded to Paxton Net2 soon. We are also looking at electronic time and attendance hardware that can integrate with PN2 (if at all) and wanted to see if anyone else ever installed this or something like this. Anyone had any experience that can help with this?
  10. W

    door entry system with log

    Hello, I am looking for a door entry system with fobs to operate a mag lock on a door. Ideally I would have a system which records of log of what fob and when opened the door. What makes would you recommend looking at or avoiding. Thanks
  11. H

    DIY smart door lock

    A few days ago I purchased a small electromagnetic door lock and I tried to make a system of swipe card unlocking and password unlocking.
    • Heriberto Batchellor
    • Thread
    • diy door lock smart
    • Replies: 10
    • Forum: UK Electrical Forum
  12. A

    Closet door jamb switch

    I have a long closet with two lights. The closet has two doors. I want to use door jamb switches to turn both lights on when I open either one door or both doors at once. Can this be done? Wiring diagram?
  13. Z

    Door Bell Transformer

    I hoped someone might advise please: I'm replacing my ancient ( probably 40+ yrs old ) door bell transformer with a British General unit mounted in a Wylex housing, fed via a switched fused spur. The previous unit had a switch only, it was fused at the consumer unit connected into a lighting...
  14. T

    Ring door bell (wired) fitted now living room lights don’t work?

    Hi all, so I bought a Ring wired ring door bell on Amazon prime day, £45 with free echo dot! Anyway fitted as per instructions and it works fine. The Ring app tells me the transformer voltage is good. BUT now my living room lights won’t turn on? The doorbell and downstairs lights are on...
    • TerryJH
    • Thread
    • bell door doorbell electician electrical work fitted lights living ring room wired work
    • Replies: 29
    • Forum: UK Electrical Forum
  15. I

    C-Tec Panel Auto Door Connection

    Evening all, Can anyone tell me if this panel has connections for a cable to signal an automatic sliding door to automatically open when the system has alarmed? Cant see to see any mention of it in the document below...
  16. J

    Ring Floodlight install above garage door

    Hi guys, I plan on installing a ring floodlight onto the brick centered above my garage door. I have some pictured attached I marked in red where I plan to run cables. My brother has done some electrical work but is not licensed electrician. Based on my research and his knowledge it seems right...
    • JoshGibson07
    • Thread
    • door floodlight garage install ring screwfix
    • Replies: 2
    • Forum: UK Electrical Forum
  17. D

    Remote light switching / electric door and gate opener on same fob

    Advice needed please - Got a job where the client wants his garage lights and driveways lights on the same key fob as electric gates and garage door. Anybody know of a product that would allow a single key fob with 4 switches to operate each of these? 2 of the switches would be at one end of...
    • Darren Evans
    • Thread
    • door electric light remote switching
    • Replies: 2
    • Forum: UK Electrical Forum
  18. timhoward

    Meter box door

    Property missing meter box door for an external box that isn't recessed. It's an unusual size (to my eyes) 555mm high by 365mm wide. I can't seem to find a door anywhere including ebay! I've used an over box for a recessed one before but this isn't flush mounted. Any thought's welcomed that are...
  19. R

    Door mag is not working

    Hello guys only me with another question. Ive just had a job come through that says the door mag is not engaging the door. On the door is a metal plate and on the door frame is another. When they connect they are supposed to magnetically stick them selves shut and you use a fob on the fob...
  20. G

    Roller Door Feed 3 phase (RCD?)

    HI all, changing a board in a commercial warehouse and they need a 16amp feed to a new roller door, there is an armored there that will do it and I'm fitting a new shnieder board with RCBO's, am i best fitting a 3 phase MCB in the board or a RCD commando by the door? Cheers Grand

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electric Underfloor Heating Electrician Courses Heating 2 Go Electrician Workwear Supplier
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

Advert

YOUR Unread Posts

Daily, weekly or monthly email

Receive a daily, weekly, or monthly email containing a digest of new and recently updated threads.

Advert

Tilers | UK Tiling Forum | Tilers Forums | Find a Tiler
UK Tiling Forum by Tilers Forums UK
Plumbers Forums | Plumbing Advice | Gas Forum
Gas Forum | Unofficial Gas Safe Register Forum
Workwear Shropshire
Top Bottom
Back