Hiya I'm looking at doing my test and inspection certs in the next few weeks and wondered if anyone can recommend somewhere reliable to take them around West Yorkshire. I know it has a very low pass rate and its obvious some places are only bothered about the money not quality of teaching. It's...
JoWW
Thread
anyone
around
electricians yorkshire
recommend
somewhere
west
yorkshire
Hi all im looking to get back in the the electrical trade after having a few years out.
I currently have my C&G level 2 and 3 2330 with two years experience on site as a electricians mate
but not sure what next steps i need to take to become an electrician .
If any one can help me out to...
Matthew Hodgson
Thread
around
electric
electrical
electrical work
electricians
electricians mate
full time
looking
mate
time
warrington
I havent come across this before, wondered if its common and what it signifies in the ring.
Remeasured 3 times and got within 20mohms or so each time so pretty sure its not a zeroing the meter thing.
2.5:1.5 TW/E ring. I went around all of downstairs rooms, did min of few sockets in each room...
SpannerSpark
Thread
approx
around
friday
pretty
r1+r2
readings
ring
socket
sockets
Done an install a couple of years back in a large building with three large sub switchrooms fed from a common main switchroom.
All lighting throughout the installation is either hf fluorescent or pl. As I say this was installed around 2 years ago with only the odd lamp failure as would be...
I have some light switches to replace in a building constructed around 1966. Theres a few broken (just worn out) although they seem like they were built to last! Steel conduit runs inside the walls & this is relied on for the earth. Unfortunately it isn't a straight swap with a modern switch...
I have installed multiple led gu10s today and the single light in the toilet and the single light in a lobby take 20 to 30 seconds to come on. Anyone had similar problems. I have always found aurora LEDs to be fine in the past.
Can any of you good folks recommend a gas engineer in Wales around the Dolgellau Machynlleth area?
I need to get a quote on a full install of an LPG system (currently coal fires only). I'd like to get someone recommended rather than a random selection, and if they can advise on tank suppliers...
In preparation of wiring up a commercial premises (function rooms / bars / restaurant area) I am trying to determine to what extent the existing 60A single phase supply might need upgrading. I have not had to do this myself for a commercial premises, and I am wondering if the same rules apply as...
Hi everybody.
I have a question (still learning, passed 17th edition and part P, but I'm not yet registered).
If you use formula from On-Site Guide p.140 what the design current you put in the formula, to calculate max length of cable for 11.5V.
If 32amp then the maximum length of ring final...
yarcyk
Thread
around
formula
length
question
voltage
voltage drop
volts
where
Hi All,
Part of the upgrade of my house involves a lot "comms kit". I have begun to build a node zero under my stairs to house network server / underfloor heating controller / AV system etc. My TV / internet / electric / F&R hot water to UFH manifold all congregate in this little area for...
Andi Licious
Thread
around
cable
cctv
electrical work
house
install
network
power
stairs
supply
Hello all, having spent a few days researching solar panels, contacting companies and doing maths I'm looking for a second opinion on my issue;
I have been tasked with an appropriate solar means of powering a static caravan 30ft x 9ft roughly in size. To fully power the home it would take...
Hi all,
I've had nearly x7 years experience as an electrician's mate working in domestic, industrial, and commercial jobs. I'm 34, and have worked hard constantly and always had people note how I can do just as good a job as any qualified sparky. I get sent to work independently, I know how to...
Pjoe79
Thread
advise
around
experience
getting
getting qualified
mate
qualified
years
Hi all!
i am needing periodic testing done, commercially. I am a landlady of a pub and I'm wanting to know what I should be getting charged or even if anyone is willing to give me a quote? I have 6 fuse boards, 46 breakers in total. I know that one board is a cat 1 and other fixtures are needed...
hey there guys,
im just nearly finishing my first yr (2330) and iv started being asked to do a few jobs, i done an outside light and had to drill through the wall,
i then quickly relized my little hammer drill was compleatly useless, lol so looking to upgrade to an sds drill.
so wondering...
Hi all, went to quote up a rewire on lighting circuit in a bungalow today. It turns out that they had new insulation laid just over 2 weeks ago. The insulators had left room around the light fittings (recessed 12v 50w halogens) but they totally covered up the transformers. After a quick look...
daniel mead
Thread
after
alarm
around
claim
damage
fire
installed
insulation
led
loft
money
transformers
Just managed to bag myself a great deal on a second hand mft 1552, Won it for £300 on ebay although no calibration cert, every other test lead is included in the sale plus the charging unit and batteries. The guy told me that getting the unit calibrated is expensive and to register myself...
Hi
I'm wiring a new house and am at the stage of sealing the boxes for behind the sockets and switches.
The holes have been tracked out to fit 25mm deep boxes and screwed in. I had been planning to finish the installation ready for the plasterer by cementing in the gap around the box but am...
Hi,
I done a bit of wireman contracting for an agency a good few years ago in various substations around the country and just wondering what the works like now? e.g. there was a big shortage at the time for us so it was decent money £20 an hr I remember.
Having been out of it, which are the...
Hi all,I'm Blair.
I've just started with New Career Skills to train as A Domestic Electrical Installer.
Currently studying for : C&G (2382), C&G (2377) & EAL (Part P).
Then onto C&G (2392) And also Photovoltaic Installers Course.
Already finding this site a wealth of valuable information so...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.