Just a quick one, I've had a look and can't find a definitive answer! Is their a minimum distance between a sink and spur for a boiler. I've just wired it all up and they have changed the kitchen and fit the sink below the boiler and spur. All I can find is 300mm distance but not sure if theirs...
Hi. I am new to the forum and most of my experience is in 12/24v systems. I have a bit of a basic question really and was hoping to clear it up. If I had one PSU with an output voltage of exactly 12 volts and 4 loads of 1 amp each and a 5th load of 2 amps all ran in 1 mm cable and each cable run...
Jamie Crutchley
Thread
cable
distance
equipment
really
volt drop
voltage
volts
Hi guys could do with a little advise on a rather large job re-wiring lamp posts in a car park. The supply will need to cover a distance of around 120M from mains to sub board where floods are already wired in 2.5mm SWA on 2 circuits the furthest travelling another 123M the other travelling...
ok.. so any help appreciated..i want to add some Klik lighting management boxes to the end of a circuit to control 10 lights. The circuit up to the ceiling rose I wish to utilise to feed my first klik is wired in conduit using 2.5mm cable. I want to add a two way lighting switch to control the...
markc17
Thread
1.5
cable
calcs
circuit
distance
lighting
using
volt drop
volts
We bought a plot of land over two years ago which had permission passed for holiday chalets. We paid the seller on completion the sum of £3000.00 to lay down electric cable and water pipes to connect us to mains supply. The cable he has installed is roughly 115m from the mains transformer. And...
Starting in September 2013 and free - https://www.edx.org/course/delft-university-technology/et3034tux/solar-energy/770 - based on 8 hours a week for 8 weeks commitment.
(There are lots of other interesting free distance learning courses at edx.org from Harvard, MIT, Berkeley, etc)
Is there any difference in minimum distance for an fsu from a hob than a
Socket. I know it's 300mm for sockets but can't find if its different for FSU's. thanks a lot.
Hi all my name is Ruari and I'm 26 I am currently trying to get my approved status(wish id done it when i was at college)and am doing the online course through Perth college has anyone else done this recently as some of the questions are bamboozling me and would like to ask some advice...
ruaribedford
Thread
approved
distance
electric
electrical
electrician
learning
Hi all,
I am looking to take a HNC course through distance learning. Can anyone recommend a good college/website for these? I live in Kent if that makes any difference.
Thanks in advance for any help,
Regards,
Matt.
Hi just fitting an Ikea double oven with total rating of 5100w, there's a 15m distance from oven to CU and its clipped directly to the wall but is Laid by some ring main cables for only a short distance to the consumer unit...my calculations suggest 4mm cable with 22.17amps, so I was going to...
Hi, 29 years old here and living in UK. Having worked dead end jobs for many years I have finally embarked on a career choice I made some years ago but have not pursued until now.
My apologies if this has been posted before, I have reading the forum for a couple of hours now and nothing quite...
Got a small job to do this week, re-routing some cables away from where a new metal chimney is going for a wood burner and I was wondering if anyone can point me at specific regs or building rules about the proximity of cables to such devices??
Thanks
Hello there.
I have been asked to look at a new supply, 240 volt to a stable block. Problem being is distance likely to be between 150-175 metres. Volt drop gonna be a problem. DNO quoted £30k to run new cable from sub. The stable block includes a kitchen, toilets, office so they were looking at...
Hi Folks,
I'm currently doing a full re-wire to the Mother-in-Law's bungalow which she has just bought. The bungalow was built around 1960's so needs a complete over-haul with both electrics and other building works.
The earthing system is TT.
Currently, the supply meter is indoors in the same...
Rik
Thread
cables
consumer
consumer unit
distance
greater
metres
protection
unit
Hi,
Looking for brief explanation about Radio regenerator and communication over long distance and maybe someone could write example where and how it is used.
Thanks
I have a job to install a flat roof system to a garden outbuilding at the end of the customers garden, Does anyone know if I need planning pertmission ? my understanding is that if the panels are mounted greater than 1m from the roof perimeter I wont require it? If this is the case it would not...
xanderfh
Thread
building
distance
mounted
mounting
outbuilding
planning
system
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.