25mm2 not SWA

[the pict]

I need to move a board and provide the supply is there 25mm cable not tails/singles or SWA, like SWA with the PVC and armour removed can we still get 16mm T&E ? havn't seen it in yonks, also where can I get bus bar to cable connections for a taking a feed out the CU to a remote RCD & OPD or switched fuse unit
Pict:furious3:

 

[stef]

Ring WF, they can get almost anything cable wise.

 

[Guest55]

Yes , you can still get 16mm t&e
PVC split con is also available in 16mm.
If the job needs 25mm cable then it will have to be swa.

 

[Taylortwocities]

where can I get bus bar to cable connections for a taking a feed out the CU to a remote RCD & OPD or switched fuse unit

Don't really understand what you are trying to do here.

Normally one would use Henley blocks but not practical if the cable is not double insulated. Perhaps connect your cable (going to the other DB) to an MCB on the non-rcd side of a "high-integrity" board.

 

[Johnuk]

there is sy or tq armored cable cost a bit more than swa but more flexable

 

[lamb]

NYY cable is SWA with no steel armour

 

[the pict]

Henly's are no use on this job, I used the unit I am after years back its like a MCB in apperance but has no switching capability, no point i using a MCB as I would need a 100A one which as far as I know do not exist
Pict

 

[Amp David]

Good God! whats this board supplying man!



MCBs > 10KA, C Curve > MCB-2100/2C - Protek Circuit Protection

 

[the pict]

It is a single phase board off a 3 phase board & I don't want to use henly's to connect into the cable from the meter, nothing more dramatic than that, good link tho I will have a look in a mo
Pict

 

[Richard Burns]

I suppose you could use 25mm H07 flex, but it would be a bit odd, but I can't think it would be a problem if you terminate correctly.