About data point . Can this work

[lumnjani]

One client asking me to replace two one gang existing RJ45 data socket . One of them have to replaced with 4 gang and another one gang replace with 2 gang. its two different office and before its was just one computer on both office . Now client wants to connect 4 different computers in one office and 2 in other office. But the isue its tha there its present just 1 x cat6 cable for each single gang socket. Im not sure if this can working if i connect as a loop or each gang have to have separate cable . What can i do. Any sugestion.

 

[Boristheengine]

Each socket needs it's own cable that eventually goes back to a network switch (such as the one built into most home broadband routers). So adding new sockets means pulling new cables.

The cheaper/easier route to add more ports for most domestic situations is to just get a cheap 5 port gigabit switch. This can plugged into the existing wall socket and then provides 4 ethernet ports to plug things in to.

 

[lumnjani]

Each socket needs it's own cable that eventually goes back to a network switch (such as the one built into most home broadband routers). So adding new sockets means pulling new cables.

The cheaper/easier route to add more ports for most domestic situations is to just get a cheap 5 port gigabit switch. This can plugged into the existing wall socket and then provides 4 ethernet ports to plug things in to.

Thanks mate. Im not involving on this situation. Just Im informing the client its not possible and forgot..
Thanks .