Accessory screw covers

[mhar]

Anybody got any tips on how to remove the little plastic inserts that the likes of Click and BG supply to cover the screw heads on the front of their switches / sockets etc? I often use a bradawl but this always damages them and is fairly obvious when they are replaced.
BG normally supply double the amount required so it is easy (albeit a bit of a pain) to collect spares, however Click only supply the exact number required. Is it possible to buy these anywhere?

 

[Toneyz]

I used to use insulation tape.

 

[Andy78]

Stanley blade usually picks them out easily.
I'm sure click would provide spares. I know Hager sell them separately.

 

[Deleted member 9648]

As above, the point of a new Stanley blade gets them out without damage, (and usually flicks them across the room!)

 

[johnduffell]

Some blu tac does it without any damage at all

 

[Midwest]

I just gouge them out with a blunt instrument, then throw them away.

 

[Midwest]

Some blu tac does it without any damage at all

How do you get rid of the blu tac stain, or do you use white tac?

 

[johnduffell]

How do you get rid of the blu tac stain, or do you use white tac?

Didn't notice any staining, the blu tac tends to stay in one lump.
Maybe "blew takk" from the 99p store would have that problem but i only buy the branded stuff from wh Smith

 

[tlangdon12]

I tend to use a Stanley knife blade, but thinking about it now, I've always got some duct tape in the toolbox, so I might try that.

 

[Rpa07]

1st attempts - insulation tape
2nd - Stanley blade carefully
3rd attempt - whatever because it’s not going back in looking nice!
The likes of Denmans Designa range give you 3 in the package which is useful as I’ve had the Hamilton verve (my favourite) only give 1 in the packet which isn’t impressive!

 

[Dave OCD]

And if you're really stuck a 3/4" screw [or other length lying round in the toolbox] a couple of turns into the centre of the cap followed by pliers on the screw.

 

[Moley]

And if you do that to all of the sockets in the house the owner will think it's normal and not complain

 

[Toneyz]

I thought that the idea was to try to take them out without damage they are not cheap to buy for what they are.

 

[Dave OCD]

My last resort method is based on the assumption you have spare/s to hand.

 

[Fitzy]

You can buy packs of these little covers on amazon and at screwfix.

 

[ruston]

As above, the point of a new Stanley blade gets them out without damage, (and usually flicks them across the room!)

Or under the couch and places never to be seen again...

 

[Bellendian]

Who actually fits them in the first place? I love Click Mode gear but never fit the covers!

 

[123]

Who actually fits them in the first place? I love Click Mode gear but never fit the covers!

It's not even been that long since Click Mode stuff has come with the little covers...a year perhaps?

 

[pirate]

The covers are a pain...makes getting at your stash a bit tricky...

Oh, come on!

 

[Silly Sausage]

Plasterboard Plug Socket Safe-Imitation Wall Socket Safe - LockMonster.co.uk - https://www.lockmonster.co.uk/item/plasterboard-plug-socket-safe-imitation-wall-socket-safe