Cleating or cable tray 70mm 4 core swa

[cliffed]

Any ideas how to bend 70mm swa cable round a corner brick wall.
It’s gotta look good,cable not yet ready to cleat,but looking at the route the only problem I see is this corner,especially with the radius bend-of the cable,just wondering how you guys would overcome it.

 

[westward10]

Inner corner or outer corner.

 

[Wes1000]

You could dress it around with this

 

[Wes1000]

What sort of height is it at?

 

[rsgaz]

Can you change height at the corner?

 

[Wilko]

Two 90 deg with vertical at corner (?) . Snap !

 

[Wes1000]

Actually if it’s not in the way could you not put it on tray? If it’s only 3 core it’s about 35mm OD so it’s bending radius would be about 250mm. If the tray came in tight on the corner of the building you would only need to stand the rest of it off of the building by 75mm to get that radius.
This is only rough workings though.

 

[Ian1981]

300mm Basket with wall mounted brackets and manufacture the 90 bend.

 

[camerabloke]

Take a brick out

 

[cliffed]

Take a brick out

Yea thought of that one,definitely may be the best idea

 

[cliffed]

300mm Basket with wall mounted brackets and manufacture the 90 bend.

Still worried about the bend radius.

 

[cliffed]

What sort of height is it at?

3 metres

 

[cliffed]

Can you change height at the corner?

View attachment 42883

Dunno if that’s possible,changing direction twice,might not look good

 

[cliffed]

Actually if it’s not in the way could you not put it on tray? If it’s only 3 core it’s about 35mm OD so it’s bending radius would be about 250mm. If the tray came in tight on the corner of the building you would only need to stand the rest of it off of the building by 75mm to get that radius.
This is only rough workings though.

Sounds good

 

[Adam W]

Does it have to be one cable?

 

[cliffed]

Does it have to be one cable?

Yea,they’ve already ducted it so far underground,after that that route is surface.