Wired all the usual for a boiler a while back, room stat in lobby & programmer in kitchen. Was an old boiler which has now packed in. They’re putting a new boiler in which apparently has OpenTherm connections, it’s an Intergas boiler. I’ve connected to an OpenTherm boiler once before & the controls consisted of a receiver beside boiler then & wireless programmer stat. My question is, are there controls & a room stat I can replace existing with to connect to OpenTherm or will I have to get rid of programmer in kitchen & fit a wireless programmer stat like I done previously?
- Thread starter SSE
- Start date
-
- Tags
- programmer
Discuss OpenTherm programmer stat etc in the Central Heating Systems area at ElectriciansForums.net
Reply to OpenTherm programmer stat etc in the Central Heating Systems area at ElectriciansForums.net
Similar Threads
i , i have a property to work on which has a programmable room stat upstairs and a programmable roomstat downstairs. S plan system , 2 zones.
hot...
Hi there,
We have recently replaced our central heating programmer with a Honeywell ST9400C. We now want to replace our old wireless room...
Hello there,
I’m in the process of mapping out a relatively standard S-plan system for my parents central heating and hot water system. Not sure...
Hi all, taken on a new build project and they have quite a large property with three separate manifolds. I have wired before with one manifold but...
What can do this to an actuator? Overvoltage? Wear and tear? Stuck pin on the valve?
This is in the German built kit house I’ve done work in...
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
This website was designed, optimised and is hosted by Untold Media. Operating under the name Untold Media since 2001.