Heating controls not my strong point but trying to change that! I have an s plan system with momo valves and have a question with regards to the closing of the valves. To close the heating valve the white goes on its own to CH off on the programmer. To close the hot water valve the white goes to HW off along with another wire from the cylinder stat. I just wondered why there is this extra wire from the cylinder stat for the hot water but there isn't one from the room stat for the heating? Hope that makes sense!
Currently reading:
s plan with momo valves
Discuss s plan with momo valves in the Central Heating Systems area at ElectriciansForums.net
- Reaction score
- 17,233
Of the valves require an off signal on an S plan then you would normally expect the heating valve to have an off signal from the thermostat.
If it doesn't then the CH valve could theoretically stay open whilst the stat is not calling but the DHW is still calling.
If it doesn't then the CH valve could theoretically stay open whilst the stat is not calling but the DHW is still calling.
- Reaction score
- 17,233
What do you mean by seems to work ok?
Have you thoroughly tested to ensure that each valve opens and closes correctly in ever possible combination of programmer and thermostat demand signals?
Have you thoroughly tested to ensure that each valve opens and closes correctly in ever possible combination of programmer and thermostat demand signals?
Reply to s plan with momo valves in the Central Heating Systems area at ElectriciansForums.net
Similar Threads
- Question
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
This website was designed, optimised and is hosted by untold.media Operating under the name Untold Media since 2001.