**Show Us Your Installs!!!**

[tomspark93]

Looks spot on mate.

Thanks

It's the dis board changes that I struggle with most to get neat, the cables are never always long enough! Some properly neat work on here lads, it nice to see people taking pride in their work!

i just find a lot of its in the planning. I tend to take the internals out and find the best method of entry for cables. Then I connect up the cpcs and neutrals (after testing of course). Then I put the internals back in connect in the meter tails and then finally the lines.

 

[uksparks]

Depending on how many circuits there are, how much time I have and what mood I'm in, I take more time I suppose you could say? I never leave a board a mess and they always look very presentable, however, some end up looking better than others.

I tend to leave a bit of length in the cables which doesn't always help, I can get a normal split board a lot neater than an RCBO board, just because of the space constraints.

Some good pictures on here though.

 

[OldeSparky]

see you have the MK lean

 

[Aurai]

Sorry it is sideways, this was an effort to bring the previous CCU from ceiling height to more accessible height using Wago Din Rail box

 

[DPG]

Err. No, it's me - I'm missing something. Daz

 

[Darkwood]

If the terminals are rated then not a problem, just a bit dog rough at the sake of replacing the back board IMHO.

Edit - I assume there are some blanks for the backboard cutouts but still would have looked more professional with a clean piece of board.

 

[Dave OCD]

Frankly that isn't the neatest ! I'd have used a backboard without all the big holes between A and B as well, is the din rail box metal ?

 

[gnselectricals]

Frankly that isn't the neatest ! I'd have used a backboard without all the big holes between A and B as well, is the din rail box metal ?

In agreement bit rough that back board.

Does the do rail box need to be metal, as it's not a CU ?

 

[Darkwood]

Frankly that isn't the neatest ! I'd have used a backboard without all the big holes between A and B as well, is the din rail box metal ?

I see your thinking but why would it need to be?

 

[Aurai]

Was never going to be sure what to do, so covered all base with inspection holes. They do have lids in the finished article. The Wago box is not metal, and decided it was not switch gear. Was curious on that point. Cheers