diy
-
M
DIY Help! Damaged Quick Connect 2 same color wires one side, Black & White the other
A quick connect on the bottom of my farm tractor was snagged by a limb and one side of the connectors wires were pulled free from the housing. The good side with the wires still connected has a black wire (hot?) and a white wire (neutral?) but the 2 wires that were pulled free from the other end...- mporch
- Thread
- black connect damaged diy help! other quick white wires
- Replies: 4
- Forum: Auto Electrician Forum
-
D
UK DIY Shocker!!!
Hi guys, I hope everyone is well. So to detail my experience, I had a loose wire behind my electric cooker mains plug, so I tested the plug after sorting the wire forgot to turn off the mains at the box and yes as you can guess as I went to push the socket into the wall to screw in, two...- DIYer Gaz
- Thread
- anything behind diy electric experienced mains never shock socket
- Replies: 58
- Forum: UK Electrical Forum
-
G
DIY upgrade lights to LED in room converted to office
I rent an old property so need to minimise any changes to it. My office is a large room (6m x 7m) with a single bayonet pendant light socket which eats thru 100W bulbs and as I get older I'm finding that there is insufficient light. So I purchased some LED light panels to install over my desk...- goenviro
- Thread
- diy led lights office room upgrade
- Replies: 4
- Forum: Lighting Forum
-
S
DIY Question: Romex routing
I am adding two additional 20A circuits to an upstairs bonus room. From the breaker box in the garage I can route the Romex up and across the garage ceiling with no problems. Once across the garage I need to route the 2 cables approximately 4' over to the point where I can punch thru the...- Sparky7
- Thread
- diy question romex routing screwfix
- Replies: 1
- Forum: UK Electrical Forum
-
A
DIY Overdrive button replacement for Kia Cerato 2006
Good day all, I'm looking for some advice about changing my overdrive button in my car. A little backstory into the situation. I had to replace my slider indicator for my automatic shifter and to accomplish this I had to cut the 3 wires of the overdrive button to disassemble the shifter...- avram2094
- Thread
- diy replacement
- Replies: 1
- Forum: Auto Electrician Forum
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
