issue

Recent contents Top users
  1. R

    UK Random electrical issue after new extension

    Hello, I’ve got an issue driving me crazy and can’t get anyone to figure it out as it’s not their issue. We had a new extension, single rear, double side. Side has utility, downstairs toilet and a bedroom above. Rear has extended kitchen, all of it is on its own wiring. Except the oven which...
  2. D

    Issue with lighting after lifting sockets to paint

    Hey, I lifted a few sockets from a wall so I could paint without having to cut in around them. I haven’t lifted any light switches yet. When re-fitting them I noticed one was a very tight fit (3 cables stuffed in to a shallow 25mm knock box. End of the ring and an extra socket coming off it?)...
  3. M

    Neutral issue wiring a smart switch for heating

    Hi. I am trying to replace a heating timer with a smart switch. The current timer is the type with a dial on the front and 1 to 24 written on it where you pull out the little lugs to set what time the heating comes on and how long it runs for, APT is the make. The wires coming from the wall are...
  4. stratus

    Garage switch stopped working after GFCI switch issue

    I plugged a drill press directly into a GFCI outlet in the garage. Something blew up by the drill press switch. Since then the GFCI outlet LED has not lit up. I tested it and no voltage is detected. I replaced the GFCI with another and it didn’t work either. What’s worse, the garage door...
  5. richardg

    Videx vx8000/s wiring issue

    Hi at a property with a videx vx8000/s keypad entry and art 836 intercom with connected phone with gate button on phone. After a drilling disaster I had to Replace the videx vx8000 with new unit and it now works with code and gate fob, but intercom gate opening button is inop. Believe when I...
  6. A

    Aircon issue - Astra J

    The air conditioning on my Vauxhall Astra J has stopped working and I'm running out of ideas on how to fix it. Steps so far: The compressor clutch is not engaging. I had the AC system re-gassed and it's not leaking. The compressor seems free to spin, so not jammed. There are two cables to the...
  7. D

    Microswitch in lighting controlled by rocker switch issue

    Hi and thankyou for reading this. I have an issue where my lights in my camper (12v LED) contain their own switch which is reset every time i use the rocker switch to turn them off. This means that i have to turn on the rocker switch and then turn on the microswitch in the lights - which is a...
  8. W

    Used Dishwasher Cleaning Issue

    I've just purchased a second user dishwasher as it was barely used. The unit is in perfect condition however the salt chamber when opened there was some thick white bits coming out collected chunks of scum and other bits. I've run a hottest setting cycle and will run a few more I've tried to...
  9. G

    Star delta issue (driving me insane)

    Heeelp! I have an 11kW/21A motor which is attached to a hydraulic power pack. I have replaced the old panels with new, using the same star delta starting. When connected to a 415V outlet protected by a C32 breaker, the breaker will periodically trip. This has only manifested since the new...
  10. clanky

    UK Meter Tails : Do i have a potential issue?

    Hello again, Was looking at installing yet another dedicated consumer box for my EV charger off the henley blocks and i noticed that a meter, which was installed a couple of years ago (outbuildings on the second phase of a split phase supply) has been wired with 16mm tails but with a 100a...
  11. G

    Issue with supply from downstairs flat

    Good evening all, So been to an upstairs flat today I East ham, the entire road is terraced 2 storey building which look like a row of terraced house but are in fact all flats one down and one up. The owner downstairs allowed me in to look a couple of weeks ago and there are two fuses one for...
    • garethmf
    • Thread
    • downstairs flat issue supply
    • Replies: 9
    • Forum: UK Electrical Forum
  12. N

    UK Light wiring issue - Looking for advice

    Hi all, Replaced a ceiling light yesterday (I'm a novice but confident with basic electrical work). All was well and working, so I turned off the lights and only at night realised the lighting circuit had tripped. Removed the new light today, assuming there was some issue with the wiring -...
    • NotALeccy-
    • Thread
    • advice issue light lighting looking wiring
    • Replies: 13
    • Forum: UK Electrical Forum
  13. B

    Retractive Switch and PIR issue.

    I've a light fitting that's controlled from a Whitecroft absence detector PIR and a wall switch. The way it works, is the Retractive wall switch with turn on the light by activating the PIR but then only turn off by the PIR’s duration or 10 minutes without absence. I’ve had to replace the PIR...
    • BobNewbie
    • Thread
    • issue pir switch
    • Replies: 1
    • Forum: Lighting Forum
  14. D

    Solar PV, diverter & car charging issue

    Hi, I have a 6kw PV with a 6kw Growatt battery and invertor. I have a solar iboost going to the hotwater tank. Recently I had a Ohme Home Pro installed. My issue is the iboost and Ohme don't appear to work in sync with each other. The iboost previously sent all excess energy to the hot...
  15. timhoward

    Strange quinetic issue

    Well this is a first.... a fault with Quinetic gear. Lighting circuit running up to loft, a box with 3 Quinetic dual receivers, and then outgoing cables to all upstairs lights. When the main switch on the CU is turned on first thing in the morning, one particular switch/light doesn't work. But...
  16. J

    Bell 801 entryphone installation issue

    Hello, I have bought a Bell 801 entryphone from Amazon UK and replacing my old one(which wasn't Bell 801). My old phone wiring diagram was numbers as opposed to Bell's one which reads IROTZ. I have tried to mirror the positioning of the cables based on the old model but the new Bell 801...
  17. N

    Bizarre Issue with Chandelier Bulbs

    I purchased a chandelier from Aliexpress (China) that came with bi pin G9 LED bulbs (3W equivalent) (pic attached). I asked the seller if this was dimmable and he said NO the bulbs are not dimmable. Apparently China uses cheap non-dimmable bulbs. But the seller told me I could purchase...
  18. L

    Theatre issue : Just about anything plugged into the 16amps trips the supply

    And the theatre claim its not their issue ! Ok..This is what Ive been told 1.Small production. Lighting etc etc all hired from a respected company who test better than most . 2. The production electrician has played around with different options to see if there could be a issue with rented...
  19. Markyd

    Forum issue, not showing threads

    Hi everyone...is anybody else getting issues with the forum not showing on screen properly, all i keep getting is a box with the alphabet in it,
  20. N

    Wiring smart light switch - neutral wire issue

    I want to install smart light switch into the wall socket that currently has a normal light switch. The smart switch requires a neutral wire which is not available in the current light switch wall socket. There’s another light switch not far from this wall socket which does have a neutral wire...
    • naik420
    • Thread
    • issue light light switch neutral neutral wire smart smart switch switch wire wiring
    • Replies: 9
    • Forum: UK Electrical Forum

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electric Underfloor Heating Electrician Courses Heating 2 Go Electrician Workwear Supplier
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

Advert

YOUR Unread Posts

Daily, weekly or monthly email

Receive a daily, weekly, or monthly email containing a digest of new and recently updated threads.

Advert

Tilers | UK Tiling Forum | Tilers Forums | Find a Tiler
UK Tiling Forum by Tilers Forums UK
Plumbers Forums | Plumbing Advice | Gas Forum
Gas Forum | Unofficial Gas Safe Register Forum
Top Bottom
Back