I have recently wired a light with intermediate switching.
when I turn on the light at one switch its fine, but when I operate the next switch it goes off! Then if I go and operate the next switch it comes on! But then if I go back to the first switch and operate that one the light goes off...
Hi All, my friend asked me for some advice but im not 110% sure. He has installed a outside security light with built in PIR detection, but also wanted it to operate as a normal light when switched. So he has wired to switchlines from a 1g 2way switch, 1 switchline feeds directly to the live of...
Hello all
This may be the second time I have posted this so apologies for any confusion.
I am trying to wire an old Victorian servant call system.
I have new push buttons, bell and transformer but the call box is original.
I can get the bell to sound but the flags inside the call box I can...
electromonkey
Thread
bell
electricians vans
hopefully
operate
sounds
van
vehicle
Hi all, i have my 2391 practical exam coming up on thursday (22nd March) im currently running through all the tests, and making a publication showing a list of tests where i can just fill in the values for each test, ive come to the function tests section, as i see it i would add lamps back in...
Womble
Thread
2391
circuit
electricians' talk
function
operate
phase
single
testing
Hello everyone,
I'm just wondering if I will be able to connect two horns both 15amps on one 30 amp relay but connected in parallel so I can operate the horns separately. So it'll be positive to the relay, then one switch to activate relay, with the two horns each with separate switches and...
Testing a RCCB installation off a Crabtree Starbreaker. TT installation. All non powered tests good however 30mA RCCB failed all tests. Even tried at the Dist. board still no joy. Replaced RCCB and still the same. Earth earth loop impedance via earth electrode is 248 ohms which although a tad...
Does an RCD need an earth to operate? I know it's additional protection and works on a balance between line and neutral but does it need earth to operate?
Thanks in advance
Ben
jamminuk
Thread
another
circuit
current
earth
electricians' talk
operate
question
rcd
require
Hey guys i have a question.
A 63A 30ma RCD main switch protecting a 20 metre run of FP200 16A mcb in a 2 way ccu.
Would you expect the RCD test results to be the same at source as you would at the end of line of the FP200?
My NIC qualified electrical supervisor basically says that he takes...
fiardor
Thread
circuit
current
device
electricians' talk
fault
operate
rcd
times
trip
As far as i know, there is no way of checking an MCB for correct operation.
Then today, i've been told you can do it by placing the breaker under load and using an EFLI tester to do it.
How the hell would this work, sound like bull to me.:rolleyes:
Hi,
Im new here, so bare with me!
I wonder if anyone can help? In my bathroom my extractor fan used to turn on at the same time when you pull the light cord.
Today, i put a new light up and when i removed the base there was 6 wires coming from the ceiling, one set of 3 had black, blue and a...
woodywoods12345
Thread
aus
electricians' talk
fan
light
operate
time
wiring
Hi everyone , i live in Manchester and have seen various jobs for meter installers, but the job agencies tell me you need to have a pto (permit to operate.)
How do i obtain this permit ???????????
Best EV Chargers by Electrical2Go! The official electric vehicle charger supplier.
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc