O
optician
Got a 3 phase board in a shop. They want me to put a couple of cicuits in to an upstairs room for pc's and a heater. Pc circuit is and extended radial off an existing clean board, 16 amp breaker.
For the heater, I was going to extend an existing ring circuit(different room).
Each cicuit is off a different phase, can I run them both to the same room?
Do they need to be out of arms reach from each other?
Do I need a danger 400volt warning sign?
Should I not do it at all?
Any advice would be much appreciated.
For the heater, I was going to extend an existing ring circuit(different room).
Each cicuit is off a different phase, can I run them both to the same room?
Do they need to be out of arms reach from each other?
Do I need a danger 400volt warning sign?
Should I not do it at all?
Any advice would be much appreciated.