Error 1

[Lighting]

Hi i have an fluke 1652b which is showing err 1 and it also needs recalibrating.
i have been quoted £250 but this is miles away and will have to send via courier can anyone point me to a company in Colchester

 

[cbw]

yep! Give me a min to pull my paperwork

 

[cbw]

On Site Calibration Services
Mr Mike Olding
01522 703002

He will come to your home or your place of work/site and do it while you wait.

Charged me £100.00 to do 2 machines and issue certificates.

I believe he charges about £70 ish for one multifunction, he does my flukes for me!

Very reliable.

His Mobile is 07776200146.

 

[Lighting]

On Site Calibration Services
Mr Mike Olding
01522 703002

He will come to your home or your place of work/site and do it while you wait.

Charged me £100.00 to do 2 machines and issue certificates.

I believe he charges about £70 ish for one multifunction, he does my flukes for me!

Very reliable.

His Mobile is 07776200146.

does he do repairs ?

 

[cbw]

I dont know.

There is that isssiisss what ever they are in Norwich, I think they may do repairs

 

[Phil]

this one ?

 

[rmaynard]

calibrating it wont cure this fault, first check the internal fuse if its ok then it needs sending back to fluke, this is the reason i have just binned mine and got a megger, Fluke wanted £198 to fix this problem.

Rob

 

[Lighting]

calibrating it wont cure this fault, first check the internal fuse if its ok then it needs sending back to fluke, this is the reason i have just binned mine and got a megger, Fluke wanted £198 to fix this problem.

Rob

Ive check the fuse and its fine so will have to go back to fluke then.

is it not worth getting fixed?

 

[rmaynard]

it may be for you but i was looking for an excuxe to upgrade which is why i chose to bin it and get the megger but if you use it a lot then its worth getting fixed

Rob

 

[nickblake]

... Error 1 is an indication that the self test has failed. And will require repair at an autherised fluke service center ACS calibration have done mine in the past the collect calibrate the last time it was done cost me £65

 

[cbw]

As said if its fudged then perhaps flog it on ebay for £100 as naffed and cut your losses.

I cannot believe how much dosh I have had for selling burnt out power tools on e bay, I got £40.00 for a fein that had caught fire in my hand!

Cut your losses and run!

 

[megger mark]

There are two types of error 1, one is a firmware up date and if sent to fluke for calibration they will do. The other is a critical fault and will be the one that costs a load.
Is the unit more than 3 years old because this is the length of there warrenty.


.

 

[Lighting]

There are two types of error 1, one is a firmware up date and if sent to fluke for calibration they will do. The other is a critical fault and will be the one that costs a load.
Is the unit more than 3 years old because this is the length of there warrenty.


.

The tester is about 4 yrs old so is out of warranty